Search results

  1. alldodge

    Dean's List gets another motor

    What I find with 454 there are cut outs for the valves, the 502 doesn't have them
  2. alldodge

    Dean's List gets another motor

    Does appear the difference in 3601 (6 point) and 3701 (12 point) but it doesn't list the lengths Which Felpro head set did you find?
  3. alldodge

    Dean's List gets another motor

    There 088 GM cast heads Also came across the head gasket issue but think were good with it. 502 STD bore 4.446 454 bored .060 over 4.310 The first 502 head gasket set picked up was larger then the bore of the 454.
  4. alldodge

    Dean's List gets another motor

    Bolts and rectangular
  5. alldodge

    Dean's List gets another motor

    Never thought head bolts would be such an issue. Mistake 1 was to use a 454 as the baseline for the head, wrong. Find a ARP kit 3607 which comes with 3 different lengths and 8 are 5 inches which are to long. Original bolts removed from head were 24 each at 4.187 and 8 at 2.187, with speck...
  6. alldodge

    Alarm and then limp mode 2015 Mercury 50 hp 4 stroke

    If this is a EFI motor look for another sensor on the head. Could be the temp sensor is the issue, otherwise need a scan
  7. alldodge

    "Christmas staff fund charge" on my marina bill?

    Malinials
  8. alldodge

    Alarm and then limp mode 2015 Mercury 50 hp 4 stroke

    If that's the ECM temp sensor then that's what's sounding the alarm, otherwise need to scan the motor to find out what is causing alarm
  9. alldodge

    "Christmas staff fund charge" on my marina bill?

    My marina hasn't started this kind of thing "yet", but they did start charging 5% if a credit card is used. Marina gets charged around 3% and they charge 5. The ruff point is if your paying cash/check you have to ask them to remove it
  10. alldodge

    Mercruiser Engine ID - No serial number

    Going to need to advise further One of the parts listed is a Sierra "aftermarket" part. Note that BAM and Mercury Marine do not list the E choke, only the dash pot Not saying your not right, but if you use Mercury parts break down its not listed.
  11. alldodge

    Winterization Question

    Not counting all the Green AF going in the water or down the sewer can kill things
  12. alldodge

    Mercruiser Engine ID - No serial number

    Post link
  13. alldodge

    Mercruiser Engine ID - No serial number

    Don't know what to say, looking thru BAM parts list I'm not finding an electric
  14. alldodge

    Mercruiser Engine ID - No serial number

    EST started in about 95 for the 3.0 The 3.0 didn't start using the electric choke til just before they went to TKS Find the flame arrestor number was used on the 470. Boat probably had a 470 and was replaced with the 3.0
  15. alldodge

    Mercruiser Engine ID - No serial number

    Made another search with a must have 15397A4 and found a carb listing in France on Rock Auto, but still no year. Could be the boat was once over seas
  16. alldodge

    Mercruiser Engine ID - No serial number

    I'm not able to find the carb number, you sure that's the number?
  17. alldodge

    Admiral's New shower

    The bath about did me in. Currently waiting on cabinets and need to trim out the window, but basically done
  18. alldodge

    496mag no start issue.

    Recorded this from one of MUC post Looks like your fuel pressure is good With no 5V the ECM doesn't know much. One thing is if there is a bad sensor the motor would start, but if there is low 5V then all the sensors are feeding bad info and the motor won't start
  19. alldodge

    496mag no start issue.

    Fuel pressure should be 39 psi but at 35 it should start. Does fuel pressure stay up when the pump stops or does it drop? Use a spark gap tester and check for spark
  20. alldodge

    Reattach cap to hull

    Is it possible that amidship the cap is sitting a tad lower then it was before? If its lower this will move the stern out further if the bacp sits lower on both ends and higher amidship
View older results
Top