Search results

  1. alldodge

    FIP 3/4x3/4 Brass Butterfly valve

    The cost is 1/2 of what hydrohoist wants for same valve
  2. alldodge

    FIP 3/4x3/4 Brass Butterfly valve

    Thanks Scott that's it. If MMC has it, there should be others Note MMC is 1/2 of HH
  3. alldodge

    Quicksilver 3000 throttle control button install

    Put handle in full WOT position and then install
  4. alldodge

    Volvo 5.0 gxi Stalls at idle. Hard start.

    Best to grab the serpentine belt and move that way. Can apply pressure to pulleys as needed to give it a bit more grip if needed Can use anything for stop bolt so long as it can be adjusted inside the cylinder Again you can remove the valve cover This is a amazon, but a local auto parts store...
  5. alldodge

    Best way to learn a language? (Spanish)

    Didn't know we had so many out of work comedians here
  6. alldodge

    Volvo 5.0 gxi Stalls at idle. Hard start.

    Could also say this could be done by removing the port valve cover and watching the rockers
  7. alldodge

    Volvo 5.0 gxi Stalls at idle. Hard start.

    Does the 50 psi stay there while running? From this post your mechanics most likely know how to remove/replace a motor, but don't know how to setup a modern motor. If it was mine I would disconnect spark and fuel to the motor. Do this by pulling fuel pump and coil connectors. Remove the...
  8. alldodge

    Volvo 5.0 gxi Stalls at idle. Hard start.

    Yes the caps have been a problem so its good to rule it out. It didn't change anything so keep it as a spare because they can go out without warning Read thru the post a couple times and I'm always missing something so bare with me. I'm figuring this is a "new to you" boat. Being a new to...
  9. alldodge

    FIP 3/4x3/4 Brass Butterfly valve

    No, it is used for air in this case but will work with water It looks the same as a ball valve on the outside, but inside it has a disc with a O ring around the outside of it https://totalmarina.com/shop-all/valve-butterfly-3-4-in-bronze-w-o-handle-for-use-in-deck-control/
  10. alldodge

    Volvo 5.0 gxi Stalls at idle. Hard start.

    I need motor serial number or something like Gxi-270-G, Gxi-J to narrow it down If it does have the flat dizzy cap, then verify it is positioned correctly. The motor is not timed used base timing mode unless it has the EST dizzy To check timing, motor needs to be at TDC on number 1 cylinder...
  11. alldodge

    Volvo 5.0 gxi Stalls at idle. Hard start.

    Which Gxi is the motor? A, C, D, 270 ...etc
  12. alldodge

    MAG 350 loses power after 20 minutes, need help

    The K&N isn't going to be an issue with SBC. A boat really doesn't need any filter with it being on the water, just something to keep big things from going in. Fella (Smitty - articfriends) on OSO did a dyno test with a (if memory serves) 600+ BBC and tried different filters, Flame arrestors...
  13. alldodge

    I'm just about ready to sink it.

    Post some pics, it might give some insight As a non-expert With shift handle in neutral, disconnect the throttle cable off the carb. Can the carb be opened to WOT by hand? Thinking there is a piece that keeps the carb from opening much at all when in neutral.
  14. alldodge

    introduction

    Here the rules are no politics, buy, sell and other things, there all written down in the stickies
  15. alldodge

    introduction

    Just scanned the thread, I'm a member over there just don't spend much time. Noticed bat wing exhaust mans and those are bad news
  16. alldodge

    Best way to learn a language? (Spanish)

    Have had the same thought but never tried any of the paid things. My grand girl mentions duolingo
  17. alldodge

    introduction

    Welcome aboard Look forward to your views
  18. alldodge

    I'm just about ready to sink it.

    Hey @Texasmark or @racerone have any suggestions?
  19. alldodge

    FIP 3/4x3/4 Brass Butterfly valve

    The 3/4 valve in the title is used on Hydrohoist and other boat lifts. I found a replacement some years ago and should have made note of where I found it. Been looking past few days and coming up empty. The reason for Butterfly (BF) valve over ball valves is the amount of pressure needed to...
  20. alldodge

    I'm just about ready to sink it.

    Welcome If it was exactly the same it would work the same. Did you swap the throttle cable with the shift cable? Put in throttle only and see which cable moves
Top