Search results

  1. alldodge

    1994 Volvo Penta 5.7 GL Timing Setting Procedure

    It's point and shoot, there is no base timing
  2. alldodge

    2003 Ebbtide Mercruiser 3.0 engine rattle? Normal?

    No fuel, that's the problem Pump gets powered from the yellow/red wire when cranking, and the purple once started. Check for power when cranking. If not present trace back to starter relay and oil pressure switch
  3. alldodge

    Anchor light wiring

    With 2 separate switches (read that at first but...) I need to see the back of the switches
  4. alldodge

    Electrical Short in all my gauages

    Same comments as in your Dec 13th post https://forums.iboats.com/threads/short-in-my-analog-gauges.752727/ Assuming the motor still runs its just the gauges Look for a loose connection, most likely a ground. Start wiggling wires behind the helm
  5. alldodge

    Anchor light wiring

    Agree, Nav should not be ON at anchor. Check for a diode on the switch
  6. alldodge

    Another transom.

    Like what your doing but as you say not so sure about treated
  7. alldodge

    2003 Ebbtide Mercruiser 3.0 engine rattle? Normal?

    Looks correct 1-3-4-2 Disconnect the plug on the right and see if it fires. If it does then its the shift interruptor If it still doesn't start with the basics. 12V at the coil Check the Dist
  8. alldodge

    Electrical Part Identification Help

    There is a fuse inside it. Somewhere between 90 and 110 amps
  9. alldodge

    2003 Ebbtide Mercruiser 3.0 engine rattle? Normal?

    Don't know about the "push pin" but if the hole is a different size then use the old, it will work fine
  10. alldodge

    deer meat question

    Pork and deer are both lean, deer more so. Need some fat
  11. alldodge

    2003 Ebbtide Mercruiser 3.0 engine rattle? Normal?

    The main jet can look different so long as the hole is the same size
  12. alldodge

    Alpha 1 gen 1 steering actuator replace with gen 2

    Mine was a Bravo and I know they are all the same. Was hoping others would say if Alphas are the same, I think they are
  13. alldodge

    Alpha 1 gen 1 steering actuator replace with gen 2

    I bought one with the quick fittings but din't use them because I didn't want to buy them for the lines coming from the PS pump. Just removed and installed direct with cheap brass fittings
  14. alldodge

    Surge brakes lasted 1200 miles of highway, whats wrong

    If wheels lock up and when released they spin easy again then they are working as they should. The shock is there to soften the trailer moving forward when brakes are applied or when on bumpy roads. Now if the trailer doesn't have the right amount of tongue weight it may bounce back n forth...
  15. alldodge

    Surge brakes lasted 1200 miles of highway, whats wrong

    Then I would think the same issue but MC must be clogged. Either that or setup is wrong, might need a pic of how it rides. Disconnect trailer then put receiver hitch in trailer coupler. Jack up one wheel and spin to see if its fee. If its free, push receiver down as hard as you can to engage...
  16. alldodge

    Surge brakes lasted 1200 miles of highway, whats wrong

    First guess is the master cylinder is not designed or modified for calipers. If its a unmodified brake shoe master cylinder (MC), then it doesn't allow for bleed back without pressure from brake shoe return springs. The MC can be modified by make a small hole in the valve at the brake line...
  17. alldodge

    Alpha 1 gen 1 steering actuator replace with gen 2

    Agree with Bondo, don't need to upgrade to the quick attach fittings, threaded works fine. They were added to make it faster for dealers with little to no leak. Correct me if I'm wrong Bondo, But the Gen 2 steering actuator should bolt right up. I think the transom plate is basically the same
  18. alldodge

    Used boat I might buy

    Entry level boat, good starter type That said, with the price, where its located and only one post I would say this might be the owner posting he wants to buy :unsure: sort of thing
  19. alldodge

    2003 Ebbtide Mercruiser 3.0 engine rattle? Normal?

    Running a tad rich, maybe the increased gap will help Check the exhaust shutters for the rattle
  20. alldodge

    Wiring diagram for 5.7 GSi PEFS? Or AQ271C? Ideally both?

    GSI
Top