Search results

  1. alldodge

    '04 Merc 2 stroke went swimming

    Cool beans (y)
  2. alldodge

    '04 Merc 2 stroke went swimming

    WD40 everything, hope it will displace anything which might cause an issue later. It displaces water and left behind it helps insulate Just my opinion, others usually differ
  3. alldodge

    gm v6 one bank of cylinders not firing

    A Nooooooooo Is it a carb (2BBl 4BBL), EFI (TBI, MPI)? Is it in a truck, a car or a boat? Does it have points or electronic ignition? Does it have cable throttle or digital control? Is this a new to you motor, or new problem? Again we have NO dang idea what the HE double hocky sticks your...
  4. alldodge

    gm v6 one bank of cylinders not firing

    Don't be go get your shorts in a bind. We have no idea what your working on
  5. alldodge

    gm v6 one bank of cylinders not firing

    BT never cared for crystal balls, just to clear :ROFLMAO: but maybe a ouija board :cool::poop:
  6. alldodge

    1989 220DA Sundancer under powered with 4.3L merc?

    Don't know first hand, but list its only 4000 lbs dry, so should do ok. Kind of light, my 23ft Rinker is 4300 and I have a single 300hp 7.4 A carry on AC is air cooled and most fit in thru the deck hatch
  7. alldodge

    V/P 5.7 GI-D not reaching above 3400 rpm

    Explain this a bit more please? And what's the motor serial number?
  8. alldodge

    Can someone identify my control?

    Howdy Thanks for the pic, but need more help to get closer Do you know about what year and is it a OMC/Merc/VP
  9. alldodge

    gm v6 one bank of cylinders not firing

    Need more info about the motor then GM V6
  10. alldodge

    Crank but want start Mercruiser 5.7

    The issue is going thru the wires is not the same as using a volt meter. A meter would tell you if there was voltage or not so you could determine what is the issue. From your statement, the connector was pulled apart and you don't know if it was the Red/Purple or the Purple wire pin which was...
  11. alldodge

    Quality gimbal bearing tools

    Can get the Merc alignment tool 91-80547A1 which is also used for TR and TRS drives, but there not used much anymore https://www.mercruiserparts.com/805475a1-alignment-tool-kt-1 The Merc gimbal install tool is several items The key one to have is the mandrel 30366 of something similar which...
  12. alldodge

    RPM falling back or motor stops

    It could be your breaker has gone bad. When it won't start measure voltage on each side of the breaker to see if its present.
  13. alldodge

    Quality gimbal bearing tools

    Find the alignment bar on ebay, just make sure to see that the seller has plenty of good reviews
  14. alldodge

    Volvopenta aq140 blowing water out of heat exchanger

    Hate to say it but you have a blown head gasket. Going to 103*C (217*F) did some damage Could also be the rebuild wasn't done right and caused the gasket to blow
  15. alldodge

    3.0 Valve Cover Breather Fittings?

    With it falling off it might just need a new hose https://www.mercruiserparts.com/bam/subassembly/30918/1604/110 That one cylinder is causing most of your blow by, bad rings
  16. alldodge

    Anchor Upgrade...need Real World Reviews

    While there is write ups, been my experience that a danforth does work in grass. Several of my Bud's boats use them in grass and they work. These are 30+ size boats. Just don't believe 100% of everything you read I use a Bruce my self
  17. alldodge

    Albemarle 24 - EFI maps and fuel return

    Don't need 10 but can use something like this https://www.ebay.com/itm/10X-O2-Oxygen-sensor-extender-adapter-extension-spacer-HHO-02-Bung-CEL-FIX-US-/312936153612 Agree carb kit would be easier
  18. alldodge

    Albemarle 24 - EFI maps and fuel return

    Once the Sniper is tuned the O2 can be removed
  19. alldodge

    3.0L Mercruiser TKS turn key start no ground

    Correct and as shown in post 3, ground is also applied once the motor waters up and the Temp switch makes connection. Then so long as the motor stays warm it will keep the ground even with key OFF
  20. alldodge

    3.0L Mercruiser TKS turn key start no ground

    On the 3.0 the TKS Blk/Yel is grounded by 2 things Temp switch makes connection after motor warms up Oil Pressure is present (motor running) Block diagram
Top