Search results

Bought 2 PTO shafts off amazon for the ones that were damaged. They show there quick disconnects on both ends were the ring type. The ones received were the single spring pin I'm sending them back and have ordered others like I wanted from Farmer Bob;)s

Yes, thankful lady luck was on my side Got the tab bent back where it should be and need to move the unit over to my shop to even use the welder. Guess I could add a double 50 amp breaker in the barn (have 200 amp service) and bring the welder over. Have a old Lincoln stick welder and have...

Normally the throttle shift cable doesn't go bad because the throttle just moves a tad more to complete the shift. What kind of shift problem are you having?

Nice work

Looked a bit further and found one of the belts broke, so no big deal. But ..... also found one of the pivot points has a broke weld, that's going to take a bit more work, bummer. Have 2 welders but I'm not that good, but the question now is do I try and hope it works out, or take it to a...

The only way to get lube inside the exhaust side of the housing is it would be cracked or a seal is leaking. Try putting a 5 inch vacuum and as Lou mentioned rotate the prop shaft There are 2 types of prop shaft seals, 2 seals facing away from each other, and a 1 piece dual seal. Both seals fit...

At your age I would replace, even more so if the drive was stored in the up position

ok, check the lube hose between transom and bell housing

I don't keep gas records but I've filled my boat up with Reg twice (about 70 gal each time) and 50 gal's once. Price was 5.25 to 5.45 for 87 Octane E0 at marina. My tank is 123 gal

Check the bilge

Your missing the point of hot wiring the pump. The relay is not the problem "we got that", we want to know if it's something else not keeping the relay energized, hence the reason we want you to hot wire it directly

Flushing bags are for outboards, the impeller is in the leg and there is no issue with it moving water. The I/O needs water pushed to it with a hose so use muffs

Looking for 2 PTO shafts in the 30 inch compressed with Quick Disconnects on each end. Found 3 different vendors and like Sutter Bros in OH the best. Going to look local tomorrow to see what I find. Can always get a longer one and cut it down

My thoughts is the beams would not be allowed unless proven to be safe. When they complete the investigation it could be they were not made correctly. Use to make floor joist with only 2x stuff until engineered beams were proven better

No nuts, 1/2 bolts go in thru bottom Finding nyloc bolts would be nice but none in grade 8

Pull the my Woods Batwing Turf mower in the fields behind my vacation rental. I keep an eye on maintenance checking gear box oil level, belts, blades, all that kind of stuff. Finished cutting the back side hills and was in the home stretch on the front side which is mostly flat. Hear a loud...

Hot wire the fuel pump

Wow, that is some cruddy looking fuel

Bummer

Understand