Search results

  1. Jim Hawkins

    Yamaha 50TLRD revs and bogs revs and bogs...

    My experience with bad fuel pumps, clogged filters, kinked hoses and all that rot is that it makes for much more sputtering and such. The way this cycles as if exactly timed makes me think it's electronic, like a capacitive circuit and as luck will have it, my girlfriends boat has the same...
  2. Jim Hawkins

    Yamaha 50TLRD revs and bogs revs and bogs...

    already tried that, thanks.
  3. Jim Hawkins

    Yamaha 50TLRD revs and bogs revs and bogs...

    This just in!!! Dramatic footage of the issue. (for the full effect, turn up your volume.) In this video you will hear the boat rev up and slow down 3 times without touching the throttle and it will just keep doing this forever.
  4. Jim Hawkins

    Yamaha 50TLRD revs and bogs revs and bogs...

    This motor has given me no end of problems. Took it out today after rebuilding the carbs and replacing 3 coils. Before that work it would not get up on plane. It idled OK and ran smooth at low RPM but ran rough and bogged at full throttle moving at a steady crawl. Now, after the work it takes...
  5. Jim Hawkins

    Electric Boats

    Well, that was fun. Took her out for a test drive. I was hoping for a calmer day but got tired of waiting. She did 3.6 mph into a 15 mph wind and 4.6 downwind ( I don't know which way the current was going). I thought it wasn't too bad for a little 2/3 HP electric lawn mower motor. I had 4...
  6. Jim Hawkins

    Electric Boats

    You guys....... There won't be any wind turbines on this boat nor any hertz changes. There won't be any dams either however there may be a few "damn's" as I tweak things. Just a simple little solar powered boat with some battery backup.
  7. Jim Hawkins

    Electric Boats

    I think with today's far more efficient panels you could probably get in the neighborhood of 2 kilowatts with a 8 x 12 roof but the main point I'm trying to make is any solar you add extends your range.
  8. Jim Hawkins

    Electric Boats

    I don't doubt that boats claim of 20+ mph but what gets me is they have an opportunity to extend range by adding a hardtop that is solar pv panels. If you park the boat when you go to use it in a few days it has recharged itself, when you cruise 35 minutes out to the sand bar and then socialize...
  9. Jim Hawkins

    Electric Boats

    So, having rotated my work through several other projects, I'm back on my electric motor. As I said earlier, this project is all about the mounting bracket that aligns the motor with the driveshaft. I realized I was wasting time trying to work around the bottom cowling just so I could re-use the...
  10. Jim Hawkins

    50TLRB Tilt Relay Mystery

    Thanks Boscoe, that's exactly what I have. I fixed the problem. Turns out (I'm ashamed to say) all it was, was a corroded connection on the switch and why I didn't check that first is beyond me.
  11. Jim Hawkins

    50TLRB Tilt Relay Mystery

    I believe your right. Having just ordered a relay from the local auto parts store for $13. On closer inspection, what I thought was original wiring was actually spliced in. Looks like that same relay is used in a lot of cars. At worst, I'm out 13 bucks
  12. Jim Hawkins

    50TLRB Tilt Relay Mystery

    So, my tilt went out for lifting the motor, down still worked so I suspected the relay. There were two so I switched them and sho nuff up worked. Now the problem, all the parts diagrams I look at show this relay for a 50TLRB But this is what I have, (I like the fuse) The only marking on the...
  13. Jim Hawkins

    Old Outboards ????

    Anyone else think the OP is a one and done poster?
  14. Jim Hawkins

    Old Outboards ????

    Prices vary by location so I can only say what I would value them at. As for the 1975, thats a little old for my taste, still uses points instead of a CDI but assuming it really is in good shape and runs well maybe a hundred or two. Now as to the 25HP, thats a nice motor and in good shape I...
  15. Jim Hawkins

    Aggravating gasket

    So, the moral of this story is I gotta get me sumathis.
  16. Jim Hawkins

    Aggravating gasket

    The green arrows show where the gasket was crimped. The other picture shows the carb body and how it (should) line up with the gasket. And that brown residue may have been some sort of contact cement. The thing is I just didn't want to believe people could be so sloppy even if they did re-use...
  17. Jim Hawkins

    Aggravating gasket

    What I didn't mention was on the bowl side the gasket lays in a groove which should make it impossible to move once the screws are tight. I really was expecting someone who has rebuilt this model carb to chime in and say they have seen the same thing. Otherwise, I suppose it's just coincidence...
  18. Jim Hawkins

    Aggravating gasket

    So, I think this is the 4th carb now (3 different motors) that I have seen the gasket misaligned like this. My first impression was just sloppy work but now I'm wondering if there could be something in the design of the carb that causes this to happen from some pressure. The red arrow shows the...
  19. Jim Hawkins

    Aggravating gasket

    Thats what I'm talking about!!! Thanks Dingbat.
Top