Search results

  1. Charlie61

    1983 115 inline mer, runing

    hello again just got motor running after replacing almost all electrice parts . starts normal, can put it in grear still runs normal. When I go to throttle up it dies . So I throttle very slow and let it run there about 30 sec. the rpm will go up. I keep doing this untill I get in to a higher...
  2. Charlie61

    Stator test In hand with an OHm meter

    Re: Stator test In hand with an OHm meter don't know size you have , here a wiring for a 83 inline 6 115hp hope it helpsgone it on line
  3. Charlie61

    lower unit seal 2

    Just replaced lowers seals in 1983 115hp inline 6 after getting help from the post. After many helpfull threads the innies in and the outties out worked . Tested it today in water and ran 10 min no oil . Thank for your help
  4. Charlie61

    1983 enrichment vale

    I have been asking for help with a 1983 enrichment vale the replacement vale it not the same at the 1983 vale the old one can be ajusted to let a small amount of fuel run thru the new one is not ajustable. this is the 3nd time I have asked. If I as not asking the right question or something...
  5. Charlie61

    Just inherited a 1995 Merc 115 ELPTO 2-stroke...now what?

    Re: Just inherited a 1995 Merc 115 ELPTO 2-stroke...now what? As far as I know you can here my rebuild 1983 ATROglass 17.5
  6. Charlie61

    83 mariner 115hp Help! won't start

    Re: 83 mariner 115hp Help! won't start this may help, my plugs where numbers going too coiles hope the help
  7. Charlie61

    Lower seal

    Re: Lower seal the inner seal is rubber and the lip could go looking at prop or looking at gears? outter seal lip go looking at gear box or looking at prop? I'm sorry it's not getting to me! I've put new starter,triper, switch box rebuild the carbs but I can not get this in my head right! I...
  8. Charlie61

    Lower seal

    Sorry but I have read and have service manual but can not understand how to install lower unit seal when I remove the old seals the inner seal was going the same way as the outter seal . I saying that the lips that gose around the shaft are faceing the same way. in the manual one going one way...
  9. Charlie61

    Repair manual for 60 hp mariner - year 83 or 84 and water pump question

    Re: Repair manual for 60 hp mariner - year 83 or 84 and water pump question the four bolts are smaller two on each side hope this picture help only one I have they are up under plate
  10. Charlie61

    Mercruiser has no poser to the dash

    Re: Mercruiser has no poser to the dash this is wiring for most boat color wiring are normaly the same i have a 1983 glasstron with a 115 inline and it working for me hope it help
  11. Charlie61

    boat size

    I have a 1971 Sea Ray 21ft lg will a mercuriser 2.5 lite work in it I got this boat after it had been redone oiutside and top hope the 2.5 will work????
  12. Charlie61

    1986 Merc 115 Power Surge above 3K RPM

    Re: 1986 Merc 115 Power Surge above 3K RPM I also have a astroglass 1983 17.5 with a 115hp inline 6 . it had not run for over 8 years. I also replaced and repaired the same as you I hope you repair the water pump .I have only had mine out one time because of bad heart you may want to check...
  13. Charlie61

    Mercury enricher vale 2

    Put new enrichen vale on , it has no ajustment no it. is now engine runs hi RPM .try to ajust cards, no help. guess I have to time it over again. I don't want a short cut but is there a better way an the book, I;m by myself and it's alittle hard to do. 2= What do I do about the new enricher vale...
  14. Charlie61

    Mercrury enricher vale

    Re: Mercrury enricher vale there a picture of the new vale it can be used on 4 diff units. if it didn't ajust I will have to think mine was bad becasue of the gas comming out the top. it was only a small amount but it would also be able to suck air in to it. hope this will helps someone.100ck
  15. Charlie61

    Mercrury enricher vale

    Hi again it a 1983 115hp inline , hi rpm last time out motor would not start. repaired staor, trigger, rec, new plugs and changed switch boxs about 4 month ago. motor had not run in 8 years , forget I rebuild carbs and water pump did all this before it would run. will after hi rpm motor would...
  16. Charlie61

    1988 Astroglass 178 bass boat Transom Help

    Re: 1988 Astroglass 178 bass boat Transom Help Like to see your boat , mines a 1983 and I just replaced floor about four month ago got fine hole under one of my battiers
  17. Charlie61

    water small hole

    I got a 1983 astorgrass 17a it's 17.5 long last time out the motor stop so I was changing battiers for troling motor trying to get back to ramp then i pulled one out I saw about a 1/8 inch hi by 64th wide water " could not see a hole" comming from where the battier was setting it's fiberglass...
  18. Charlie61

    wiring

    Re: wiring if you go to www.maxrules.com you could find all the boat the wirering you need for motors and part by numbers the one I attach is for a 1983 mercury 115 hp inline good luck
  19. Charlie61

    1985 merc 115 intermittent surge ! Switch box ?

    Re: 1985 merc 115 intermittent surge ! Switch box ? Hi Ireplaced only one switch box in my 1983 115 inline runs great but it is hard start cold P.S. I just got it from boat angles for $235.00 1983 astroglass 115 inline and trailer. replaced floor and new carpet some electric wiring
  20. Charlie61

    lower gears

    Hi first time motor ran in 8 years I put new stator,trigger, switch boxs, motor running great. Run about mile or so stop fished. wanted to move. running great slower down to take vido of motor working to send to wife. was running slow gave it some gas and it started up then on power, motor...
Top