I/O (Sterndrive) Conversion to Outboards

[tpenfield]

Ted must be busy grinding

I am glassing today . . . not quite warm enough, but I got a heater going and using 2.25% MEKP . . . seems to be working . . . but it is not quick.

 

[tpenfield]

The sun is shining so I'm doing some more glassing. I did the crossbar pieces over the past couple of days, and today I glassed the center stringer . . . 4 layers wet-on-wet.
.

.
With the sun out, temperatures in the boat are 80˚F, even though it is only 60˚F outside. To keep the coldness out I put some plastic over the transom cut-outs and set them in place. It's a good thing I didn't toss them

 

[redneck joe]

I thought you were leaving the keyhole open for access?

 

[tpenfield]

I thought you were leaving the keyhole open for access?

"set them in place" to keep the cold out. They will be gone once I don't need them.

 

[redneck joe]

Forgot you were in Yankee weather....

 

[Scott Danforth]

Ted, will you be adding shelving to hold the beer er provisionings in the old bilge area? if you need a design for a service elevator, let me know. we did one that brings a blender and booze from below deck galley up to the cockpit. 2 ball-screws, a kevlar belt and a small DC gear motor. it would raise and lower up to 150#