Search results

  1. A

    Removing regret

    Now that is old gasoline !!
  2. A

    1986 johnson 20hp tiller electrix start

    Not a good thing to rev up in neutral no matter what brand of motor !! Being an older motor, hopefully your looking for a factory service manual ?
  3. A

    bogging down after 5mins

    Check your fuel for water !! Where you buy your fuel can make a big difference !
  4. A

    1986 johnson 20hp tiller electrix start

    I am a picky old fart, if I loan something out, I expect it to come back like you got it, if it doesn't you won't borrow from me again. For this reason, folks are happy to loan me things as they know I will take care of it and make any repairs that might be needed if I mess something up.
  5. A

    Boat Pricing

    Are all those fancy trinkets hiding more serious issues deep down inside ?
  6. A

    1986 johnson 20hp tiller electrix start

    To each his own, but I am a big believer in doing things correct the first time. Hate doing the same job over again, especially because I cut corners. I would do a thorough clean and rebuild with a kit to be sure the carb will not be an issue.
  7. A

    Removing regret

    Must not have used that nasty old E 10 fuel that ruins everything !
  8. A

    1986 johnson 20hp tiller electrix start

    If your going to spend the time cleaning the carb, grab a " factory" rebuild kit so you have all new gaskets and the instructions for proper setup.
  9. A

    Random

    Wow....you can go 15 minutes ?
  10. A

    Transom replacement or design flaw?

    We need to remember that this is only a 12' aluminum rowboat, a basic model from Starcraft. Max HP rating is 10 hp, and that was probably rated with a lighter weight two stroke. Replace the old wood with some good plywood and the boat will be better than new !! Most all small row boats have...
  11. A

    Transom replacement or design flaw?

    Have saw many rebuilders just add an aluminum piece between the rear of the tank seat and then to the transom riveted or screwed in place to stiffen the transom. Back in my younger days, made a few myself, then no holes thru the bottom !
  12. A

    !/2 ton Truck towing limitations

    If you towing serious weight over distances and at speed, then a WDH is necessary, but for occasional short tows, it really doesn't matter unless the weight is really excessive. Living near lake erie, the walleye capital, most of the trucks I see towing larger boats are defiantly not setup for...
  13. A

    Should I Buy A Jackplate

    Been setting up boats and motors for over 60 years. My go to setup is to adjust the trim so the cav plate is parallel to the bottom of the hull. A long straight edge along the bottom then trim your motor until the cav plate is parallel !! Now measure how high or low the cav plate is....adjust...
  14. A

    WHY I HATE RUSTOLEUM AEROSOL PAINT

    Rustoleum has more particles in their paint, thus extra shaking is needed to mix it thoroughly. Been using the stuff for decades without issue, but I spend at least 10-15 minutes shaking before use and continue shaking as I use it. Cheap paint cans have far less paint particles in the mix...
  15. A

    Transducer mounting best option?

    Are you using this just to read the depth, or are you needing to scan the are for fish or other details ? Just as a depth sounder only, shoot thru the hull if you can get it in a good position. If your needing underwater details then a transom mount is needed. With today's adhesive's ...
  16. A

    Should I Buy A Jackplate

    Unless your trying to get every single mph out of your boat and motor setup, no, it is not worth it ! However there are folks that will spend big bucks for a couple more mph.
  17. A

    Transom replacement or design flaw?

    Owned many small 12' and under aluminum boats over my 60 plus years of boating, not unusual to see some flexing at the transom. How much is ok is the question !! These small boats are made to be light in weight so they can be cartopped. The makers use minimum strength materials to save...
  18. A

    Deep Cycle Battery not good for starting??

    Sounds like your asking your battery to handle to much draw. When a battery gets drawn down then only a partial recharge before being drawn down again is not healthy for the battery. Just starting your motor should not wear it down that much but then add the ff's and other accessories then...
  19. A

    Deep Cycle Battery not good for starting??

    Were you using that battery for anything other than starting your motor ?
  20. A

    Hydro sheild

    They do work on small underpowered boats and motors. As a machinist I have made a few over the years for small out boards that actually worked quite well. Today, many folks have a poorly balanced boat and motor combo, improperly setup and expect an add-on fin to cure there problems. Many folks...
Top