Search results

  1. K

    Replace Teleflex or go hydrolic?

    Google Panther Marine Troll master. They make remote control steering, throttle and shift wireless controls for all popular small outboards.
  2. K

    4.3 omc cobra no start

    There is something else to try, get a jumper wire and connect the + or Bat side of the coil to a constant 12 volt source, spin the engine over and check the color of the spark. Your problem may be the ignition by-pass circuit in the solenoid. In the meantime try to get a dwell meter. If you...
  3. K

    302 distributer

    Chris , I stand corrected on the MM distributor application. I am glad you was able to find the application. I did not know that MM made distributors, the reason I described them was from the Holley distributors used in the fleet of International Harvester trucks that we serviced at my Dad’s...
  4. K

    302 distributer

    That is a Holley. One way to tell is the small split in the base of the mounting plate near the contact points. You might have to contact Petronics as I could not find a Holley kit listed in the Sierra catalog.
  5. K

    302 distributer

    There are 4 different distributors used on the Ford 302-351. Mallory, Pertronics, Ford & Holley. Most common are Petronics & Mallory. Post a picture of the points and then we can tell which one you have.
  6. K

    Is it worth it?

    One thing worth checking is if there is excessive wear in the distributor. Remove the plate and check that the weights, springs and slop in the shaft upper bushing. There is a bushing in the block that supports the lower end of the shaft which wears out. The easy cure is to add a bushing to...
  7. K

    1970 OMC CUFM-69B Impeller access

    When you get the service manual and I hope it is a GENUINE OMC, you will see the drive being worked on mounted in a special holding fixture. Without them it is a real PITA to work on. I have performed this many times, for you I suggest first drain the upper gear housing. It is not necessary to...
  8. K

    Volvo Penta AQ140 water coming out of carbs.

    The replacement engine looks good from the outside. Those are tough engines and give a lot less trouble than the later models. I hope you got the PDS housing with it. Good luck.
  9. K

    New gimbal bearing, can’t get alignment tool in coupler

    To check if the rear engine mounts have collapsed is with a sharp pick try to rotate the insulators on both sides. If you can move them the mounts are still good. One reason why Mercruiser wanted the open side of the gimbal bearing carrier facing forward is someone started selling just the...
  10. K

    5.0GL - No Power at Coil

    Try to get the original one rebuilt, 120 amp would be good if you had some high dollar sound system in the boat. You should be able to find a rebuilder in your area.
  11. K

    Test stand running 70's 350 water hook up

    A drippy Quadrajet can be caused by a plugged air bleed in the Venturi. Or a vacuum leak also. A tiny piece of wire, carburetor spray or compressed air To clean it. Or if the idle is too high. Try to get the engine to idle as slow as possible when setting the timing. What is the timing set...
  12. K

    Test stand running 70's 350 water hook up

  13. K

    Ran motor (in driveway) without oil in lower unit?

    It appears you are having trouble with the front stud that is bound up through the lower part of the drive shaft housing. Raise the drive all the way. Get 2 pieces of 1” wide X 1/4” flat steel and grind them to a round end to fit in the pocket. Get a propane torch. Back the 2, 5/8”O.D. hex...
  14. K

    Need to ID motor

    If there is a drain screw below the intermediate ball gear shaft then the housing has been changed some time after 78. That is good for you. The shaft may have the double tapered bearings. However you need to fill it from the bottom.
  15. K

    Volvo Penta AQ140 water coming out of carbs.

    That engine must have broken the timing belt, otherwise it would have hydro locked and not turned over. 2X with Scott on the carburetors.
  16. K

    Volvo Penta AQ140 water coming out of carbs.

    If you reuse your twin carburetor on the 130 it should bring that engine up to the original engine’s power.
  17. K

    5.0GL - No Power at Coil

    Your alternator may have a stud marked “stator”. It is only hot when the engine is running, it should have 12 volts. If you have that setup connect the choke to that terminal. You do not want to use the circuit that powers the coil. Another way is with a electric fuel pump safety switch that...
  18. K

    Need to ID motor

    The other screw on the starboard side above the lower is just a vent as the housing gets filled from the lower drain hole and an indicator if the case was full. If you have a dip stick in the top of the exhaust housing cover then you can use it to gauge when there is enough oil in the gear...
  19. K

    Need to ID motor

    Starboard side of the gearcase.
  20. K

    Removed the Wrong Screw

    Remove the drive like Scott said then stand it upside down, you should be able to fish the piece of metal that the screw went into and reinstall the screw holding the plate in place. Worse case scenario with a service manual separate the upper from the lower if you cannot fish out the plate with...
Top