Search results

  1. R

    Mercury 9.8hp 110.. fails to get water to cool engine

    You installed the correct factory impeller?----Measured to fit the different diameter shaft on these motors ?----Removed exhaust cover ?-----Perhaps there is a hole in it.
  2. R

    Mercury 9.8hp 110.. fails to get water to cool engine

    Is the water in your test bucket 6" above the impeller ?
  3. R

    Mercury 9.8hp 110.. fails to get water to cool engine

    So you did not inspect the washer at the top of the tube ?
  4. R

    Shift rod length

    They made a 5" coupler for the water tube.----At $50 it sounds like a farmer used a cheaper option.----Might just remove what is there and measure to see if it will reach into the water pump grommet.----You ordered a new short shaft or used ?
  5. R

    Mercury 9.8hp 110.. fails to get water to cool engine

    That is where water is supposed to leak out into the exhaust.-----I suspect and have seen it more than once that plastic washer at the top of the water tube is melted.----Remove powerhead to inspect this.----The replacement factory washer is now a better quality.-----I keep some on hand myself.
  6. R

    1986 murcury 60hp only starts and runs in high idle.

    Post the actual compression values on this motor.----Was water pump maintained ?-----Mixed gas and oil at 50:1 in the tank ?-----If you can repair it yourself it is worthwhile.----If you have to pay $2.00 / minute at a shop it will be expensive.-----You might even have trouble finding a shop to...
  7. R

    Shift rod length

    The model # suggests your motor is or was a short shaft.----Is there a 5" spacer between lower unit and exhaust housing ?------You will need a short driveshaft.----Short shift rod would be 5" shorter than the long shift rod.
  8. R

    Exuast backfires 1976 25hp evinrude

    It is a simple procedure.-----Perhaps you can find a video on U-tube.-----Explaining this to you.
  9. R

    Merc outboard serial number question

    I usually find 3 of the 5 bleed inserts missing !----But I can not inspect your motor !
  10. R

    2000 Johnson 50 hp engine surging

    Model # of this motor ?---I assume a 2 stroke.-------Have you checked the gear oil ?------I know for a fact that these gearcases ( 2 stroke ) are not robust.------See if there are any metal bits on the drain plug magnet !!
  11. R

    No spark on Merc 85hp

    One good battery will do.----Use booster cable directly to the starter to eliminate the cables / solenoid as the culprit.-----Find the issue with the system.----Take starter apart.----Very easy.----Then do an ohm test on armature.------Perhaps replace brushes.----Inspect cables.----Not sure why...
  12. R

    Merc outboard serial number question

    Nope--Not the power ports.--Those holes ( circled in red ) must have a nylon insert with a specific hole size.----They are called " bleed inserts " by Mercury.-----I often find 3 of 5 missing.-----I install 8-32 stainless setscrews with correct hole size in them.----Never to go missing again.
  13. R

    Baltimore bridge hit by ship, collapsed

    100,000 tons.
  14. R

    Johnson temp issue

    Marine engines need a new rubber impeller about every 5 years !!
  15. R

    Johnson temp issue

    Agreed----Impeller is at least 7 years old and likely not replaced by previous owner.--So could be 15 years old.----Put a new one in every 5 years.
  16. R

    Exuast backfires 1976 25hp evinrude

    The flywheel taper and crankshaft tapers must be lapped together for a precise fit.---Use valve grinding compound.------The key locates the flywheel for correct timing.----The flywheel is driven by the locking tapers.----And 50 ft-lbs is correct for the flywheel on a 76 model 25 HP.----Tapers...
  17. R

    2000 Johnson 50 hp engine surging

    Test run with another fuel tank.
  18. R

    1976 25hp evinrude snaped exuast

    I think you candle this job on your own.----No need for the industrial language.
  19. R

    Exuast backfires 1976 25hp evinrude

    Are you sure wires are colored like that on a 25 HP 76 model ?
  20. R

    Mercury 75hp 1986

    A 2 stroke.-----Mix gas / oil 50:1 in the tank.
Top