Search results

  1. Faztbullet

    Impeller Failure Help

    How is impeller failing? vanes ? hub?
  2. Faztbullet

    What oil to use?

    If you Google "Pennzoil Premium synthetic in yamaha hpdi" you may find you mechanic is misinformed.
  3. Faztbullet

    Slow crank on initial start up

    I see this when impeller start to harden..I would change inpeller first.
  4. Faztbullet

    Can I add an Oil Pump to a Yamaha CV85

    Go to a synthetic oil and reduce smoke and fouling and use the CV85
  5. Faztbullet

    Prop ventilation?

    Take that old 2 blade Merc prop off and install a 3 blade and raise the kicker to decrease drag on take off
  6. Faztbullet

    Can I add an Oil Pump to a Yamaha CV85

    Doubt it as designed as econo 50/1 motor
  7. Faztbullet

    1989 Evinrude 140hp rough idle

    Make sure the crossbar linking L & R carbs together is correct as they will slip and cause carbs to be slightly cracked open on one side
  8. Faztbullet

    White Smoke😑

    In both post there is no H2O ejecting from water pump indicator... could be getting hot at low speed
  9. Faztbullet

    No high pressure from FSM

    Check the rubber coupler on fuel pump.
  10. Faztbullet

    2000 Yamaha 50HP bad center cylinder

    Most likely center failed before and was repaired but original problem which caused failure was not fixed..see it all the time in customers DIY repairs
  11. Faztbullet

    2000 Yamaha 50HP bad center cylinder

    That center piston doesnt look OEM...and its not a no oil problem
  12. Faztbullet

    Temp difference port to stbd ,head ,Tstat .2000 200hp Saltwater series 2 stroke

    Normal
  13. Faztbullet

    Winter Storage - Grease on cables

    Mercury 2-4-C grease
  14. Faztbullet

    No high pressure from FSM

    High pressure pump run when key cycled?
  15. Faztbullet

    Cylinder Compression Incongruences.-

    Head needs to be surfaced.you can torque all day on a warped head and still wont pull it flat
  16. Faztbullet

    Water in cylinders

    Forget what I posted above as for different forum. If your getting water in bottom cylinders most likely the divider plate or power head gasket blown.
  17. Faztbullet

    Water in cylinders

    Foam cast block ...no exhaust covers. Make sure correct gaskets used, not 3L on 2.7L block
  18. Faztbullet

    Mariner 30 water leak in cooling system

    Head froze and cracked....pull head and repair
  19. Faztbullet

    Water in cylinders

    Head gasket or block rotten from salt water.
  20. Faztbullet

    outboard was very hard to start after sitting a while then smoked a lot

    30 mins and a manual
Top