Search results

  1. Faztbullet

    My 1997 150hp rebuild

    Got pics of cylinders/pistons?
  2. Faztbullet

    2013 Merc 115 FI will not start

    Check to see if fuel to vapor separator and high pressure fuel pump come on when key cycled. Check onboard engine fuses.
  3. Faztbullet

    My 1997 150hp rebuild

    Oil starvation will effect ALL cylinder not just a couple. Only reason to sleeve is if webbing broken out as can get various size pistons. I dont think it was oil problem
  4. Faztbullet

    fuel filter part

    Seirra 18-7979
  5. Faztbullet

    My 1997 150hp rebuild

    Bore all 6 .015 or .020 over..shouldnt be over $500. If it was oil starved as you stated really need to look at crank/rod surfaces. What cylinders failed?
  6. Faztbullet

    08' Honda 150hp 4-stroke Heat Alarm

    You need to replace impeller also
  7. Faztbullet

    Johnson 150 Rebuild/Remanufacture Guidance

    Break it in with XD50
  8. Faztbullet

    Concerned about damaging ignition system 1988 115hp L6

    Those are comments..not facts.
  9. Faztbullet

    1991 Mercury 40HP “Classic” Plug Fouling/Stalling

    You have the correct rivets...you take a flat punch and tap it in
  10. Faztbullet

    1970 evinrude 85hp starflite no spark

    How was points wired backwards?
  11. Faztbullet

    Mercruser alpha 1 gen 1 stern drive issues

    Take the drive back off, clean all that silicon and sealer off bell housing and drive, then install the correct gasket and transfer o-ring.
  12. Faztbullet

    No power to coil

    Checked shift interrupter?
  13. Faztbullet

    Mercury Alpha One Gen II Upper Gear repair

    You need to take lower apart also as they share the same oil so all that debris is in lower unit too. You will need a press to remove/reinstall shaft and shim tool to check height. Also will need to check preload on gear/bearings on horizontal input shaft and clearance. Might be best to take to...
  14. Faztbullet

    Will not turn over with all plugs on.

    Replace the solenoid
  15. Faztbullet

    Carburetor question on restoration I’m working on 1992 40 hp MSHQ Yamaha

    Take ya 3 pallets ,stand on edge and make a triangle. Put 2 concrete blocks on bottom and chuck it over the side in 6-15 ft of water near a ditch or creek bend. Bait it up with several cans of cheap dog food and da crappie will come. Have several dozen set out.
  16. Faztbullet

    Carburetor question on restoration I’m working on 1992 40 hp MSHQ Yamaha

    Plugs are fine..the Lucas has a detergent in it makes it run cleaner and will actually decarbon some. Just quit looking and go fishing.
  17. Faztbullet

    Carburetor question on restoration I’m working on 1992 40 hp MSHQ Yamaha

    Well a engine can run lean at WOT if fuel pressure is low, float level set to high and fuel/oil mix if premix is to rich of oil....
  18. Faztbullet

    Converted my 1999 2 stroke 9.9 to a 15hp

    Mercury does the same exact thing on the inline motors...a 90 has has less reed opening than a 115. A smaller pitch prop will improve hole shot but rarely adds increase in speed.....
  19. Faztbullet

    Carburetor question on restoration I’m working on 1992 40 hp MSHQ Yamaha

    Plugs are only clean if: water intrusion which plug tip will surface rust after setting, fuel wash from flooding carb/s or excessive lean at WOT.
Top