Search results

  1. alldodge

    Fuel pressure adaptor

    Yep, its Actron 0180-000-1320 , just look for GM TBI fuel pressure adapter
  2. alldodge

    5.0l cobra efi no power to fuel pump

    Have limited amount of info on the TBI, but start/run should be similar. The relay would be my first thought.
  3. alldodge

    Blue Seas Add-A-Battery Kit - 120A 7650 - need a wiring diagram I/O and kicker

    This should work It can be done with 3 bat switches but 2 will work. The House bat switch should only be used to combine bats if start bat is to low to start main motor
  4. alldodge

    Ignition Switch Confusion

    This is the reason I mentioned an inline fuse or fuse panel. On your style boat, the fuse is normally not on the helm but under it using an inline fuse
  5. alldodge

    5.0 mpi overheat at higher rpm.

    Pic to help
  6. alldodge

    5.0 mpi overheat at higher rpm.

    If you see bubbles then your sucking air. If you notice your cooling during normal operation is, thru the engine water pump, thru block, out thru thermostat housing, to exhaust. When thermostat is closed there would be a small amount of water coming from the block and out the exhaust. There...
  7. alldodge

    5.0 mpi overheat at higher rpm.

    Ok you have the single point drain system with the Alpha drive. https://www.mercruiserparts.com/bam/subassembly/31849/8093/200 Place a clear hose between item g (cool fuel) and f (water dist housing). Then see will in the water if there are any bubbles. Also use the pic to make sure the...
  8. alldodge

    Bravo I, II & III interchangeability question

    From your previous post your needing the bell housing (part of the transom assembly), and yes most any can be used with one caveat. On top of the face or the housing look for slots on the top. The slots are there so the U bolts do not come in contact when fully raised. You can use the one...
  9. alldodge

    trim/tilt line leak repair help

    Appears so, you know more then I. This kind of lines the O ring does the sealing but nut has to be tight. Th
  10. alldodge

    2001 sea Doo GTX RFI

    From looking at the manual it shows a Black/Pink and Purple/Pink wires feeding the pump. Guessing from the colors I would say Purple/Pink is hot and the other is grounded by the computer to turn it on
  11. alldodge

    Click but no start

    Howdy, we need to know what motor your working on (merc, VP, 3.0, 5.7 etc)? Once we know we will have a better idea of how to fix it and maybe GA_Boater will move it to that section Is the battery fully charged and measuring between 12.5 to 12.7 volts? Are the battery cables clean at both...
  12. alldodge

    water not draining in engine compartment

    I doubt if there is a drain. Most cases it gets drained when the boat leans enough to dump it in the bilge. Here's mine (not a searay) on the starboard side, and it use to be flat until I did transom repair
  13. alldodge

    Mercruiser 555 - ECM no power?

    Sure looks like the same ground, note splice 104 on letter m which is everywhere CAN, sensor and ignition
  14. alldodge

    Mercruiser 555 - ECM no power?

    Yes your thinking correctly, in typing I switched the tags, its correct in post 6
  15. alldodge

    454 MAG. BRAVO MPI (GEN VI) GM 454 V-8 1997 Crank No Spark

    If your meter is good, the 12.3V is barely on the good side, and a bit low. Should run if it ever starts
  16. alldodge

    454 MAG. BRAVO MPI (GEN VI) GM 454 V-8 1997 Crank No Spark

    Removing the red kills all power to the coil so there will be no spark Code 33 is MAP voltage high, so disconnect MAP connector and measure voltage on Lt Green and Gray. The MAP will not keep the motor from firing Check out your distributor
  17. alldodge

    Octagon Window and Siding

    Nope, not what I'm looking for, that is they make a piece and then you cut to fit. I have a brake and can bend my own aluminum, so I can make brick molding. The brick molding in the link does not cover the inside of the frame. In pic below, blurry on left is current window, and one on left is...
  18. alldodge

    Octagon Window and Siding

    Getting the materials together to vinyl side our rental house. The house has 2 octagon non-opening windows. They are wood and the molding extends out more the the J-channel. I want to cover all the wood I can to seal it up, and I have a aluminum brake. I can bend 8 pieces on metal, and try to...
  19. alldodge

    Crankshaft position sensor replacement

    The CPS is the same part number for both motors that use a Cam sensor and ones like yours which do not. Backfiring and having trouble to idle would have me also looking at timing, IAC and distributor cap. You mentioned that the distributor cap was replaced, and if the motor has the same issues...
  20. alldodge

    Rocker switch panel

    You can feed all the switches with a buss bar, and have a separate fuss for each one
Top