Search results

  1. C

    1964 Johnson JW-19M Restoration project

    no known antidote .... I already have a cd11 waiting for next winter in my basement....$80 US with nice tank how much was your JW??
  2. C

    70 Johnson 9.5 points?

    You are welcome glad it is fixed happy fishing :) thanks for the feedback.. we all learn from good feedback btw see great article on condensers 4 part series by W.Mohat you even build a nice test box ..I did & it works GREAT! https://wrcoutboards.org/magazine-articles/
  3. C

    70 Johnson 9.5 points?

    the job of the condenser is to protect the points from arcing to much...! time for new condensers ! and points :-)
  4. C

    70 Johnson 9.5 points?

    see MQ topic & others http://www.leeroysramblings.com/OMC_info/OMCinfo.htm
  5. C

    Motor wont start....help please

    After peeking in the bypass covers or pulling the cyl head one would still be at step1 to recovery. A can of decarb product may or may not help but as far as Seafoam it seems to do some improvements compression wise see video . I have used it on my snowblower with sneezing and...
  6. C

    70 Johnson 9.5 points?

    according to Leroy'S these 9.5 are low comp. engine. if it works don't fix it I never had much over 70 on half a dozen 9.5s ! Leroy's ... Compression : Compression on these motors may seem lower than some of the others. Displacement of the these 9.5 hp motors is 15.2 Cubic Inches...
  7. C

    70 Johnson 9.5 points?

    could be just dirty carb now.... unscrew the bottom front bolt on the carb and the LS needle give it a shot of carb cleaner to clear any crud build up and reinstall. if it does not work service the crab see Leroys... these 9.5 must be 100 % clean to run good This carburetor must be...
  8. C

    Motor wont start....help please

    try a good decarb product Merc POwer TUbne ... a bottle of seafoam in a 2gal of fresh agas... some like seafoam some don't .. but try it
  9. C

    2009 etec 60HP cranks but won’t start

    well... I just noticed you have been on the ETEC board :) I doubt you will get better help than the ETEC folks.... no offense to anyone. I hope you find an inexpensive fix buying a used ETEC without a good service check is always risky....
  10. C

    2009 etec 60HP cranks but won’t start

    injectors need fuel.. it think 30psi is needed and you need to check that. the lift pump can be bad as well as the high pressure pump on the vst you have a VST and like other VST your may have a "non-displayed" on the parts diagram cone filter ......which can be clogged. it is...
  11. C

    1987 Johnson GT 150 power trim problem

    thanks for your feedback... which wire where ??
  12. C

    Evinrude 15hp hard start.

    when it does go with a shot of starter fluid try pumping the fuel hose to see if it keeps going .... if yes the fuel pump my need a close look at seems we had a case some time ago when the little crooked tube (part #4) which feeds the idle circuit was an issue. make certain the idle...
  13. C

    1961 Johnson 10hp - QD 22 - Leak

    if you have no water in the gearcase don't worry about it to much
  14. C

    05 Johnson

    true... yet my ETEC still purrs and roars after 16 years :-) but I know it won't last 50 years like carbies.
  15. C

    05 Johnson

    probably loves gas a lot compared to an ETEC or other injector models!
  16. C

    2010 etec 60 hp starting problem

    thanks for your feedback...we all learn from feedback
  17. C

    1961 Johnson 10hp - QD-22 - Fuel Pump Issue?

    ground to pump.. 2-3 feet . may be a bit high have you tried a normal 12 inches or so... if ok pump is good ..for now
  18. C

    Thermostat impellor question

    impellor is not a big costly job... why not change it instead of risking broken parts going up and blocking water circulation temps at 80 measured where ?? did you scan the PH with an infrared meter to check block temps by the looks of it thermosttat may be open so you may as well...
  19. C

    2001 Johnson 175 engine cover

    car auto-body shop may be able to fix it up not to expensively compared to a new cover.... shop around all depends how bad it is .........cracked only or missing parts ?? I fixed up my ETEC 75 hp lower housing halves with UV glue afew years ago. still holding strong
  20. C

    1957 Thunderbird Warrior - 1962 Evinrude Starflite IV - Intro

    this site has seen some pretty ugly ones but your rig looks nice & If it lived so long it was cared for. check the transom for abnormal flex... if it was run regularly it may just need fresh gearcase oil if no water intrusion detected , a new impeller and a good shot of quality...
Top