Search results

  1. jerryjerry05

    91 Force 40 runs rough

    Missing at idle usually means the low speed air screw needs adjusting or it's sucking air somewhere??? Do the starter fluid test: spray sf around the intake side of the motor, base of the carbs and under the coils and packs and around the fuel pump. If this makes any difference?? then it's got...
  2. jerryjerry05

    1984 Force 85HP starter will not operate - all wiring appears to be correct

    The rectifier has nothing to do with starting, only charging.
  3. jerryjerry05

    Chrysler 35 hp 1969,Suddenly no sparks at all

    You shouldn't be able to see sparks when you activate the choke. Possible your burning up the condensors when you short the solenoid?
  4. jerryjerry05

    T&T leakdown tests

    Did you do the leakdown tests? The tests isolate and can pinpoint the problem.
  5. jerryjerry05

    Force 85 really difficult to start

    From the color scheme it's an 87. You need to figure out the starting procedures??? #1 squeeze the ball until it gets hard, if it doesn't get hard, then the fuel pump might need a rebuild?? #2 throttle advance, depending on the shifter, you either pull the handle out and push it forward, or push...
  6. jerryjerry05

    1984 Force 85HP starter will not operate - all wiring appears to be correct

    Some solenoid need to be grounded. The Force's I've seen have the ground wire on one of the lugs,
  7. jerryjerry05

    New NGK BR8HS plugs improve overall performance

    Some motors can use any brand. Some just don't run right when you use NGK and others Champion?? I've had 2 88/85's that it didn't matter the plug??
  8. jerryjerry05

    Force 125 lacking power

    If the air screws need to be almost all the way in?? You probably have an air leak somewhere? Do the starting fluid test and see if you can find it?
  9. jerryjerry05

    AQ125 Oil pan

    http://www.volvopentastore.com/ This site has every VP made since the 70's Find the 120 and 125 and compare the part #s???
  10. jerryjerry05

    How many bearings in the SX-M between gearbox output and propeller ?

    Little more info: Gear box? The transmission? or the top of the drive itself? http://www.volvopentastore.com/ This site has parts diagrams for almost every VP from the 70's to present.
  11. jerryjerry05

    Filter crossover

    Mercury 2016 60hp 4stroke The filter is 35-8M0065103 Any idea what a crossover filter would be? I'm installing the Mercury one` but was curious what the other is? TY!!!
  12. jerryjerry05

    PM not working????

    Hey Mods, saw I had a message. Opened it and it went crazy. Flashing and flipping and not working right????
  13. jerryjerry05

    25 2009 F25LA operating range rpm.

    200925hp What's the max rpm's ? It's on a Geeno and it doesn't seem to be operating, running up to speed. I have a Tiny Tach and will find the rpm's at wide open. Just need to compare to the right specs/ THANKS!!!
  14. jerryjerry05

    DVA or Peak Reading Voltmeter, what is it and what does it do??

    Got this email from CDI Ignition. Explains the DVA Meter and attachment for a regular analog meter. Maybe include it somewhere in the stickies? Maybe testing stator, trigger etc.?? WHAT IS DVA??? So just what is DVA? More than likely you have heard the term but have never understood exactly...
  15. jerryjerry05

    2010 115 TLR 4st.

    How do you pressure test the high pressure pump in the VST? It does't have a Schrader valve? Thanks.
  16. jerryjerry05

    98 30hp.

    98 30hp. Today, 05:00 PM 98 30 hp on a 16 ft. alum. Jon boat.Bass tracker. What size prop should I get? . THANKS!!
  17. jerryjerry05

    115 Yam limp mode.

    Yamaha 115 4 stroke. 2001 Turn the key on and an alarm comes on and doesn't go away. Not over heated. Cold motor. New impeller. Starts but goes into limp mode?? what to check?
  18. jerryjerry05

    Johnson 225 2005

    Starts and runs and then after a while as much as an hour it bogs and won't accelerate. Not running hot. Good comp. no water in fuel. Filters clean. Any idea what the fuel pump pressure should be? A customer called and gave me the description and asked for help?? Had a similar problem with...
  19. jerryjerry05

    2002 115 4 stroke gas in the oil.

    Working on a 2002 115 4 stroke. Change the oil, has about 2 gallons in the oil pan. Smells a little like gas???? \ ANY ideas?? THANKS!!
  20. jerryjerry05

    Yam 2002 115 4 stroke

    What oil/weight for the crankcase? Quantity? THANKS!!
View older results
Top