Might just be one of the switches bent bad, happens quite often.
With it running pull the lead off to see if alarm stops, or pull the switches and test them
Check connections on the injectors. Need to know if something is keeping them turned ON
The ECM fires injectors with a ground being switched. With key ON and motor not cranking should see 12V on both pins. If 0V is seen on one side this means a ground is applied and keeping it turned ON
A...
Your slave solenoid is bad
Having less then 5V on the Gray to Blk/Pink means one of the sensors is pulling to much current or the ECM has an issue. With key ON, disconnect the CPS and see if 5V comes up. If it doesn't reconnect the CPS and one by one disconnect the seawater pressure, oil...
Haven't said what motor
All filters
If lube was not changed prior, change
Check all rubber, water/fuel lines and replace if hard
If I/O grease input shaft
Check gimbal
Something isn't adding up for the parts list.
Post list S/N is 2B185185 and when it is used it shows the diagram shown in post 1, but the hose going in at the bottom of the FSM comes from supply. This hose should not go to anything that connects it to the motor where it would come out the...
The slave relay may be clicking but it's most likely not making good contact inside, so it's not passing enough current to energize the starter. Turn key ON and then use something to go across the top contacts, this will energize the starter. If starter does not energize when contacts are...
Sounds like if it was ok where your at, if you go boat some where else, that it may not be so good
At least where not in another country. Seen some across the pond that must be 5 inch high
Most likely standard for all, but in KY I could show pics of ones that could only be read up close, and no where near 3 high. Wondering if others have same issue.
Guessing, all along the IC its 3 high and clear or there are cops showing up
Just wondering which do
KY requirements states minimum 3 inch high, block letters and contracts color (fade colors ok so long as they contrast). Most what is seen is any but
Not a comment on adhesive but foam.
Doesn't take much to keep the foam up but regular egg create foam in a engine room gives me the willies. If it ever starts to burn it will go up like a match
Fire proof sound insulation like:
https://www.walmart.com/c/kp/fireproof-sound-insulation
They make the ones with a check ball tht keeps water from going out the drive when a hose is attached, but I would like ball valves. Either 2 on 2 in one like the webstone
