Search results

  1. alldodge

    Mini split outdoor condenser rodent guard advice

    Looks good but might ask the manufacture if putting the screen around it will reduce the flow enough to cause an issue
  2. alldodge

    Always thinking about the 'next' boat . . .

    The Chappy 280 and 300 OSX helm seat will pivot and lock in either position. Can also get the boat with a fixed helm seat which is a few inches wider and a wet bat behind it. Mine is coming with the pivot seat, don't use the wet bar on my PC
  3. alldodge

    350 mag mpi strange fuel pump relay problem

    Should not see 12V on both sides for pump to run. The ECM applies a ground to pin 86 when key is turned ON for a couple seconds to prime fuel rail. Once pump stops running 12V will be seen on both 85 and 85
  4. alldodge

    Always thinking about the 'next' boat . . .

    At least Cruisers used Verado instead of Yam Nice looker
  5. alldodge

    U/V light to control mold etc in basement, attic?

    Only reason in my pea brain that there would be moisture in an attic is there isn't enough ventilation, a leak or bath vent is not exhausting outside As for basement, I'd use a dehumidifier
  6. alldodge

    Mercruiser 4.3 alarm won’t stop

    Need to use Merc HP gear lube which is 90W Ya did fill the drive from the bottom?
  7. alldodge

    I assume I need an engine alignment, vibration when drive is engaged

    As mentioned in post 3, 4 and 6 It starts when placed in gear, meaning once prop starts turning
  8. alldodge

    15 HP Mercury 4-Stroke water in oil

    easy place to start
  9. alldodge

    I assume I need an engine alignment, vibration when drive is engaged

    If there is "no" vibration when the motor is running and only vibration when in gear, then its most likely in the lower section or the prop. Start with the prop to see if it was installed correctly and is tight.
  10. alldodge

    vista 268 Bildge pump

    The bilge pump needs to be wired direct to the Bat so it will turn on with the float switch. Can also wire for manual operation like in pic. The alarm can be left off or most just wire a light in
  11. alldodge

    No emails

    It does seem to happen every once in a while. Wonder if it has something to do with gmail. The Formula forum just updated and now I'm not getting it from them. OSO started working but a week later it stopped again
  12. alldodge

    No emails

    Anyone else not getting email updates? Started yesterday but still happening
  13. alldodge

    Overheating Problem

    The pump is not able to bring in enough water. The VP Dudes will be along shortly but with pump being new and if the hoses are on correctly, then its the intake piece on the bell housing or the drive
  14. alldodge

    15 HP Mercury 4-Stroke water in oil

    Need to find where the oil is coming in at, if it's a crack or a gasket. My guess is its just a gasket/seal. Would suggest start taking the motor apart until the issue is found.
  15. alldodge

    Which States/Provinces Enforce Registration Numbers Requirements

    Same as most LEO's will do nothing if your speed exceeds 5 MPH over, and very few will bother with 8 over. My observation, if your on the great lakes or coast line, then do it according to the Reg's. If your inland not many will pay any attention unless your doing something stupid Sorry I...
  16. alldodge

    Which States/Provinces Enforce Registration Numbers Requirements

    Good grief, now your quoting Fed Reg and laws Post 1 Soooo, not every place does enforce to the exact letter of the law
  17. alldodge

    Ignition

    Call around your local auto parts places, might get lucky. Also many times Walmart might have it in the marine area. If they do you should be able to find it online and select the store and it will show if it can be picked up
  18. alldodge

    Ignition

    All good, you can get the entire assembly or just the fuse inside as pic above
  19. alldodge

    Ignition

    Yes, that is the Alternator protection fuse. If its blown then 12V will not pass. The fuse is inside the block. Check continuity from the small bolt to the large tab
  20. alldodge

    Ignition

    Well ya got to start with what are you working on? In your other thread it's probably a 2007 3.0 with AG2 drive. Could use your motor serial number. Going to need a voltmeter. There is a 90 Amp fuse on the starter post, it's square looking and has the fuse inside it
Top