Search results

  1. alldodge

    Volvo Penta 5.0 GL-C Rebuild Help

    DO NOT try to remove motor without pulling the drive first Do use sealant on head bolts and permatex is fine Do NOT use anything but the head gasket as isthe mentioned Use RTV Black on intake and timing chain corners
  2. alldodge

    DTC 113: IAT voltage high ( please help )

    No I don't, its just the one image I have the manual but it does not show the location Not that said, there is also a MAT/MAP Manifold, Air Temp/ Manifold Air Pressure. It has more wires and also sits behind the TB https://www.ebay.com/itm/265509894027
  3. alldodge

    Urgent help - boat fell off trailer while backing down ramp

    Really, don't see it going down, only up
  4. alldodge

    Hard starting

    Watch
  5. alldodge

    DTC 113: IAT voltage high ( please help )

    I'm not a VP guru, just using your motor to find the items. It shows at the VP website where it is https://www.volvopenta.com Go there and then select "engines" then start entering 5.0G ....etc until your motor shows up. Select and then find the intake
  6. alldodge

    Hard starting

    Your running rich, and while a 454 is listed to use close to 750 CFM, being a 1990 you would have peanut port heads. They do a nice job of low end torque, I'm not seeing that amount of CFM at WOT Your plugs look fairly new and would clean up if we can get the fuel under control. Get the air...
  7. alldodge

    Steering bracket help 1959 lark 35

    I'll call some members Hey @racerone @jimmbo @Texasmark @Faztbullet need some ideas
  8. alldodge

    4.3 L exhaust 90 degree drain cracked in manifold

    On muffs there will be very little if any pressure. Go to hardware store and pick up a hand full of rubber or wood plugs and a roll of electrical tape. Push the plugs into the manifold elbows and if need be wrap so tape around them. Put muffs on a fire it up. Once its running the guy your...
  9. alldodge

    Urgent help - boat fell off trailer while backing down ramp

    You have thru bolts so that's a Gen 2 Whats the thing bracketed on the upper?
  10. alldodge

    Liquid in VST float?

    No, never Doesn't matter if its in a carb or VST
  11. alldodge

    DTC 113: IAT voltage high ( please help )

    The DTC 113 is set anytime the IAT voltage is above 4.95V and will display on the scanner 110*F The IAT is a 2 wire sensor and screws into the rear of the intake behind the Throttle Body (TB). Find sensor, turn key ON without starting and measure the voltage across pins (A and B). A is power...
  12. alldodge

    Steering bracket help 1959 lark 35

    You asked a question about something that needs to be seen. What if I asked you Have you seen my boat it sure is pretty, what do you think?
  13. alldodge

    Need Help With Finding Insurance

    There out there, but be ready to pay to have your boat surveyed. Also remember, many agreed to values does not cover everything that may happen to it. Read the fine print ad understand it Also be ready for the price tag of an agreed to value. Many insurance companies have been taking a bath...
  14. alldodge

    No start situation

    No, 1.25 to 2.25 is within range from my view. Check the float height, most likely its to high
  15. alldodge

    Hard starting

    Factory shows 72 / 84 or 73 / 73 with 6.5 power valve for 750 cfm Looks like they have been changed, most likely for similar issues. The factory setup is to get it within range. Changing jets by +/- 4 usually means there is something else going on. Yours being black might be the power valve...
  16. alldodge

    No start situation

    Thats flooding
  17. alldodge

    Hard starting

    Going to look up the sizes but your plugs are saying there is to much fuel
  18. alldodge

    5.7 GSIPEFS Timing??

    Was this 2 different things? Marked Dizzy and pulled Then rotated motor to TDC
  19. alldodge

    Hard starting

    Your getting to much fuel, and the second pumper is just adding more. The 4150/4160 come in a variety of configurations (single, double, E choke, etc) and good thing is they are easily changed. Do you know what jets are installed?
  20. alldodge

    4.3 will not run

    woops your right, tx
Top