Search results

  1. alldodge

    Low power under heavy load

    Being the old ones there not bad, tad rich but ok Have you run the boat enough to burn up most of the old gas.? Old gas doesn't get better with snake oil (sea foam or other), just need to remove or burn enough to get rid of it.
  2. alldodge

    Minor Surging After Carb Rebuild - TKS 4.3 '06

    I'm thinking need to get back into the carb for adjustments What are the compression numbers?
  3. alldodge

    Low power under heavy load

    Would need a serial number to verify but being a 01 I would guess it has a TKS carb. Your issue soulnds like it needs a carb rebuild What do the plugs look like?
  4. alldodge

    350 mag mpi 2000 won't start

    Unsure but could be a MEFI-1 or 2, in any case trouble shooting will be the same. Is there 12V at the coil with key ON? When cranking can you see the Tachometer show at least 300 rpm? Need a 12V resistor LED or a digital multimeter with a tone check. Connect the LED or meter as shown and a...
  5. alldodge

    Replace water inlet hose on Bravo 3

    ok, look for "shields marine 1 1/4 intake hose" intake/exhaust hose
  6. alldodge

    Replace water inlet hose on Bravo 3

    Your PN is bulk hose I used 8M0090859 to replace mine https://forums.iboats.com/threads/bravo-itis-fix.680176/
  7. alldodge

    350 mag mpi 2000 won't start

    Kill switch, fuel pump, IAC, ECM, blown fuse Check for 12V at the coil Do you here the 2 beeps and the fuel pump turn ON when key is turned to ON? What is your serial number?
  8. alldodge

    Manufacturer letters pealing off

    New boat, why not take it to the dealer to fix?
  9. alldodge

    Velvo penta does on water

    If your compression gauge is accurate then motor is good enough to run even with the one low cylinder. I'm out of ideas
  10. alldodge

    Bad gas

    Sounding like the pump is bad Could hot wire the pump so it will run for a bit to see if it will pump up
  11. alldodge

    Bad gas

    Take a gas can and put the fuel line going to the filter in it. See if it will bring up the fuel to start the motor
  12. alldodge

    Need help with sterndrive parts

    Did you look down inside the exhaust tube to see if its clear? Every year its best to pull the drive, check gimbal bearing and also alignment. Bearing is checked by putting you fingers in the bearing and turning. It should feel smooth as silk. Alignment needs and alignment bar to check
  13. alldodge

    120 Mercruiser 2.5L - No spark

    There is no base timing mode or shut for your distributor. Just point a shoot to set timing
  14. alldodge

    2000 Sea Ray 5.7EFI alpha 1 gen2

    I'll let someone else answer that one
  15. alldodge

    2000 Sea Ray 5.7EFI alpha 1 gen2

    The permalube is the same on both sides and should see a white dot The old style with cutouts , the center sticks out further if put in backwards Again main reason is to find out who did the work and is it fully seated
  16. alldodge

    2002 volvo penta 5.0gi TBI only starts with throttle

    Did you change all of these items? What is the fuel pressure?
  17. alldodge

    2000 Sea Ray 5.7EFI alpha 1 gen2

    Was the gimbal ring put in correctly, and is it seated fully? Look at the gimbal and if you can see cutout on the outer edge of the race then it was installed backwards If the same mechanic that installed the gimbal is also telling you its good, then suggest ask another or check your self
  18. alldodge

    Need help with sterndrive parts

    Just guessing but the shutters are item 6 and have to remove the elbow to get at it. Can also look down to see if other items are there https://www.mercruiserparts.com/bam/subassembly/30906/11669/190
  19. alldodge

    60A Circuit Breaker pops on engine shut off

    Breaker might be the issue and needs replaced Get any 60 amp fuse you can find and replace the breaker with the fuse. If it blows there is a real issue This is for 2 fuses but should be able to find just one https://www.amazon.com/Blue-Sea-5253-MIDI-Fuse/dp/B00I0A0U9I
  20. alldodge

    max size for video?

    No vid can be attached that I'm aware of, they all get posted to another site like youtube or other and linked here
Top