Search results

  1. SweeperForce

    Gear oil change

    Hello, I have two questions Today I tried to replace my lower unit gear oil. I removed th top two screws one said vent and the other said fill. The screws had what looked like a washer or gasket of some sort which was all chewed up. Should I replace them? In order to drain the gear oil I...
  2. SweeperForce

    Choke solenoid

    Hello, I was looking in my manual and a choke soleniod was listed for every motor except my 1989 150 horse. My choke is activated by pushing the key in while turning it. Did my motor not come with a ckoke soleniod? Thanks, Tom
  3. SweeperForce

    Trim unit operation

    Hello, How does the trim and tilt system work? Can a motor stay tilted back even without a battery? I know it runs by hydraulics, but don't the battery power the rams. Thanks, Tom
  4. SweeperForce

    Starter and trim problem

    Hello, Yesterday I attempted to start my motor after sitting the best of two years. I tilted the engine back to remove the transom saver, then tilted all the way down into a big bucket of water. To make sure everthing works I just turned the key without the choke engaged. The starter came up...
  5. SweeperForce

    Skeg

    Helllo, I know there are alot of skeg post but I have a different question. Should have a new one welded on or can I just bolt on a skeg gaurd for now? Thanks, Tom
  6. SweeperForce

    2 cycle oil tolerance

    Hello, What is the margin of error when mixing 50:1 two cycle outboard oil. If I need 12.8oz for 5 gallons and I put in 12.5 or 13oz will I have problems? The example above is about +/-2%. The motor is an '89. Thanks, Tom
  7. SweeperForce

    Cfi

    Hello, I've been reading in here about people having carb problems, if my cowling has CFI in it that means its injected no carbs, right? 89 150 hp force outboard Thanks, Tom
  8. SweeperForce

    Prop size

    Hello, I am going this weekend to look at a boat and test run the motor. The seller don't have a hose so I'm buying a sterilite container and filling it with water. What are the measurments of the lower end for a 1989 150 hp Force outboard? Will a 25 gallon measuring 24"L x 18W x 17"H work...
  9. SweeperForce

    Old gas

    I'm buyibg a boat that hasn't been ran in 2 years. It is an 89 Force 150 hp 2 stroke. The boat has about half a tank around 8 gal. The guy said as long as the gas has oil in it, it is good. Sounds a little fishy to me. Also can I use syn oil in an old motor? Thanks, Tom
  10. SweeperForce

    Tilt Lock

    Hello, In my travels over the internet I saw a sort of locking device while the motor is fully back. I have been instrusted to use a log or peice of wood to prop up the motor. I have to store my boat at a storage place during the week and plan to disconnect my battery. I rather not have my...
  11. SweeperForce

    Engine Manufa.

    I recently purchased a 150 horse Force. It's a 1989 inline 5 cylinder. I can't get a straight answer anywhere. Can anyone tell me who made the Force, Mercury or Chrysler? Thanks Tom
  12. SweeperForce

    New owner

    Hello, I just bought a 1989 EbbTide 180 with a Force 150 CFI outboard. The lower end has been rebuilt and new wires were installed a few years back. The boat and motor has been sitting and not ran for two years. Other than spark plugs what else should be replaced? Are there any filters or...
View older results
Top