Search results

  1. M

    Yamaha 130 mounting height

    Getting ready to mount my 2001 yamaha 130 hp v4 onto my 1997 wellcraft 190 ccf. It has a stepped transom. Should I make the cavitation plate even with the very bottom of the keel? Or raise it 2 inches? Currently has a johnson 115 and two my eye the cavitation plate is 2 inches above the bottom...
  2. M

    Yamaha 130 hp v4 2 stroke

    Yeah I tested by disconnect and put power direct still no good. Yes 2 wires. I found a sierra brand for 125 new on ebay. There quality is supposed to be a little better than most hopefully
  3. M

    Yamaha 130 hp v4 2 stroke

    I have power as close as I could get to the trim motor. Test light flashes when pressing up or down. Is the trim motor rebuildable easily enough? Are the aftermarket ones any good. Not ready to shell out 500 bucks on oem at this time
  4. M

    Yamaha 130 hp v4 2 stroke

    Relay has been replaced. Relays are good
  5. M

    Yamaha 130 hp v4 2 stroke

    New to me motor. 2001 yamaha 130 hp. Power trim relays click when activated by trim switch but no movement or noise from trim motor. Anything to check? Motor sat for 2 years. Chance the motor might be stuck from sitting?
  6. M

    Multi function yamaha tach

    You are. Great. Thanks
  7. M

    Multi function yamaha tach

    The only thing that doesn't make sense to me is that in the diagram it shows colors yellow,blue,black,green going into the tach (bullet connections). My colors from the bullet connectors of my external key switch are yellow,red,black,green. I ordered a dual fuse harness for guages and the one...
  8. M

    Multi function yamaha tach

    Thanks. Looks like I'm on the right track
  9. M

    Multi function yamaha tach

    Still wrestling with this but getting closer. The wires under the hood have the following pictured connections. Do I need a oil and trim harness to plug into these? Neither of the 2 connectors have the normal green for trim down blue for trim up. Does this look right to you. Also pictured is the...
  10. M

    Yamaha which tach?

    I'm getting confused. Can someone give me the part numbers for either a analog tachometer or digital yamaha brand tachs. Prefer the multi guage with power trim indication. I have a 2001 130 hp v4 2 stroke with remote oil tank. I will be using a 704 binnacle remote control and a yamaha key switch...
  11. M

    Yamaha remote oil tank location.

    Hi my used tank did not come with the hose.
  12. M

    Yamaha remote oil tank location.

    Ok thanks I'll order that hose
  13. M

    Yamaha remote oil tank location.

    Yes. Any recommendations
  14. M

    Yamaha remote oil tank location.

    So it looks like I'm going to have to put my remote oil tank for my Yamaha 130 v4 in my center console and run a filling hose from a deck fill cap cut into the side of the console. Boat is a 1997 wellcraft 190ccf I know the remote tank harness is long enough but what to use for the hose from...
  15. M

    Multi function yamaha tach

    I don't know. There are several wires there. I assumed green but I could be wrong. Also is a trim sender standard Equipment on the 2001 yamaha 130 v4? I have a 1999 version in my garage and I don't see any trim sender wires coming out of the hole in the bracket where the main power trim motor...
  16. M

    Multi function yamaha tach

    Ok I think I get it now. The green wire from key switch panel goes to the tach for tach signal after being carried via 10 pin harness to the switch . Sounds better to me now if that's correct .
  17. M

    Multi function yamaha tach

    I don't see orange wire on engine side wiring.
  18. M

    Multi function yamaha tach

    Thank you that is very helpful. So I need a trim oil harness with 2 plugs on both ends and the interface harness to use the digital tach. How does. Rpm get handled. It's not in either of the 2 trim oil harness?
  19. M

    Multi function yamaha tach

    This is the analog tachometer with power trim guage and the digital also with power trim guage on right side
Top