Search results

  1. C

    77 115hp no spark

    agree but no volt is a result not a cause ... must find the cause first
  2. C

    77 115hp no spark

    and all 4 coils are open on secondary side. (tested between the spark plug boot and ground)... hum ??? boot to frame ground open may simply tell you that a- the pin pricks and spring coil in the boots are oxydized b- the plug cable connexion to the coil is oxydized ( parts pictures...
  3. C

    1990ish Evinrude 6hp not idling

    you can try a good decarb like POWER TUNE from Mercury follow instructions . Some folks like SEAFOAM some don't ... BRP also makes a decarb product ..... a good strong run may be all it needs to rid the cobwebs from the innards
  4. C

    !!1970 evinrude 6hp fisherman 6002b idle issue!!

    check compression, check electricals (points ,condensers, timing) , check throttle position adjustment carb should not leak one drop... reclean adjust the float http://www.leeroysramblings.com/OMC_6hp.htm Johnson (leeroysramblings.com) Boatinfo - 1956-1970 Evinrude Service manual the...
  5. C

    1990ish Evinrude 6hp not idling

    I agree a new top is best of course but just for a trial, seeing this a hairline crack it should soak a touch of crazy glue . a top layer of Bondic should do the rest. Bondic is pretty amazing stuff and sets up hard in 3 seconds using the provided UV lamp. ..just like dental repairs.
  6. C

    Evinrude or Johnson ??

    Antique and Classic Outboard Motor Paint & Decals (nymarine.ca)
  7. C

    Free manual link.

    Boatinfo - The library, containing manuals, brochures and other technical documents from the last hundred years! Boatinfo - 1922-1964 Johnson Service Manual
  8. C

    How to take the lower unit off

    open the side plate on the lower housing and unbolt the shift rod if you are planning to work at this .... may as well get all the info from .... Boatinfo - 1922-1964 Johnson Service Manual
  9. C

    Evinrude or Johnson ??

    Amazing that an oldy from the 50s can look pampered or mint condition run like a top and simply be piece of manufacturing history yet a somewaht more modern engine can look like an abused oldy ready for the junk yard :-( :-( .
  10. C

    1990ish Evinrude 6hp not idling

    feeds the low speed cct of the carb with fuel
  11. C

    When do you replace the fuel filter?

    I think the filter is porous metal so it won't deteriorate much a good cleaning or two should do you can always remove it and install an in-line filter on the incoming fuel line (easier to maintain, and you can see if crud made it's way in from the tank
  12. C

    1990ish Evinrude 6hp not idling

    could you seal the crack with crazy glue... cover it with a layer of Bondic glue (UV) which is pretty amazing. It works like dental repair filler I have repaired the plastic bolt retainers on my 75hp ETEC lower covers saved me a ton of money >$2000 & been holding strong for a...
  13. C

    When do you replace the fuel filter?

    try soaking lacquer thinner then cover the both ends with one end with a 1/ 4 openning to blow dry it repeat a few times
  14. C

    New water pump not working.

    drop the lu put it a large bucket of water and spin the drive shaft...with a drill doest it pump or not ??
  15. C

    trim relay mystery-2000- 150 h.p. Johnson

    relays are identical . in this latest picture one is flipped 180 degrees pin 87 is the actuator pin from the up and down switches +12v supply and pin 86 is the ground side of the coil blue -white and green -white are the "activate" wires to energize the relays.. one at a time...
  16. C

    trim relay mystery-2000- 150 h.p. Johnson

    has indicated the motor works with Bat & grd in alternate directions either one relay is not putting out it's 12v while the other one properly appies a ground to the other wire or vice versa one relay is not providing a proper ground while the other relay puts out 12V to reverse...
  17. C

    trim relay mystery-2000- 150 h.p. Johnson

    Here is a UTUBE of a 2 wire system... may not be yours but basically all the relays will do is apply juice to the trim motor one way and reverse the juice polarity to reverse the direction so it is important that while one relay applies +12V on one side the other side must have a...
  18. C

    1990ish Evinrude 6hp not idling

    venting ok ?? try openning gas can cap o see if it runns better try pumping the bulb if better possible fuel pump or simply a dirty pump filter under the fuel pump cap , bad hose, dirty fuel pick-up in the tank etc... after that were are talking carb clean-up , bad coil etc.... New Page...
  19. C

    trim relay mystery-2000- 150 h.p. Johnson

    op... wrote swapped working relay from up cycle and now down trim works wiring should be ok no ?
  20. C

    trim relay mystery-2000- 150 h.p. Johnson

    it clicks so the coil is probably ok can you open the relay itself without destroying it.. could be just dirty contacts inside . if accessible burnish the contacts seeing you are sol on the relay .... try a small 1/16 drill hole and spray some wd40 inside or...contact cleaner...
Top