Search results

Verado is 7.4 quarts Electric steering much better than hydraulic. Down side can you steer if pump doesn't run, found out by accident I can it's just hard My Cummings 6.7 is 3 gallon of full syn and change every 15K

Don't know of anyone which makes them out of pipe anymore, round is hard to keep in position with a set screw or clamp under heavier loads. I made a adjustable trailer using 1 inch threaded rod and weld a plate on top, used a nut to adjust Could use galvanized pipe from the hardware store and a...

For flushing find what ever is cheapest, your not going to put the motor under load so no issue. Do agree lower weight like 10w30, could use 0w20 but that's synthetic and probably cost more

We haven't talked about that yet, they should tell me today how they want the deposit. :unsure:

Your doing good Pressurize to 15 psi to where it will hold and maintain. If it holds and then good

Correct, When docking I move the legs out about 15*

Welcome Post a pic of starter with wires connected Moved to Mercruiser

I went around and around with Chap right after purchase and all they said is this is how we build it. If I had only one motor it would be 3.5 turns but add another and same lines and pump and you get 8 Did find that if the lines were increased to about 1/2 ID with adjustable helm you can change...

@Scott Danforth @kenny nunez @Bt Doctur

It's mostly handling during docking, OB just don't bite like IO and then add to it hydraulic steering. Instead of 3.5 turns lock to lock it's 8 turns. Could be joy stick would make it better but it's a light boat with a hardtop, and the top makes it a sail in the wind. I the boat weighed another...

Yes there is some air and how much depends on how the drive was refilled. On the boat, off the boat and angle. It also takes a little time for bubbles to work it's way out

Remote non-remote, filter will be the same thread

Spring lake Michigan

Yes has Cats and I don't like them either Think all since 2012 or 2014 something like that

Depends on fresh or salt water, I'm in fresh so don't worry much about corrosion. Impeller is cheap enough, everything else is not like Fuel cooler $2K,

Search for "gm oil pump primer tool" and several will show up Your motor may be fine, I'm just saying you need to get the water out if you want to keep it. You can run any motor for 30 seconds without water, but do remove the drive. Get all the water out, put fresh oil in and prefill the...

yes, comes in goes back out warmer

No, No, unless ......... you want to have rusted and scored internal like bearings. Need to get the water out and have everything coated with oil, if any water is present it will rust. There is no short cut It won't cost much to take things apart, only when putting back together. Take exhaust...

The motor is closed cool including exhaust manifolds The raw water system feeds water thru cool fuel, heat exchanger, power steering cooler and out exhaust elbows The hoses numbered 36 are the connection to the cool fuel CAT closed or open cooling is a very large spaghetti mess Looks like...

Correct cool fuel is raw water cooled