Search results

I agree!

So I guess the air pulls from the slot opening at the top of the throat opening. The cork gasket and airbox does cover the air jet completely leaving the notch below the air jet to provide air. Hope that made sense

Noticed on my 86 evinrude 70 hp that the airbox and corresponding cork gasket closes off the small jet at the top of the carb when bolted to the carbs. Seemed strange to me. I'm assuming it's normal. Just thought it seemed strange. Anyone know how this works being closed off.

Ok thanks. Although max Timing on this one is 19 degrees. I set it to 15 degrees per joe reeves method

Thank you for that info

Ok good to know thanks

I think you are right I am missing the other half of the plug that would go to the solenoid. Yes that red wire runs close to the solenoid. I will check for voltage in a couple days when I get a chance to fire it up

Seloc manual. I know not the best

So I guess I can cut that open plug off the red wire and hook it to the 12v battery post of the solenoid and I should be ok?

According to the wiring diagram I don't see anything coming off starter solenoid that would connect back to red rectifier wire

I still have a connector with a fuse in it connected to the 12v battery post on solenoid

This is the wire that was currently hooked up to the red wire from the rectifier (at the terminal block). The rubber half a connector is just loose not connected to anything but is located near the starter and solenoid

I have a red wire that ends with an open socket single pin connector. It goes from the red rectifier connection point on the terminal block and runs to the port side near the solenoid. I must be missing another piece of that to connect to the solenoid? Motor runs fine but not charging

That's the problem. The wires on the new rectifier are readable but the motor wires not too much. Where does the red wire come from?

I have an 1986 evinrude 70 hp 3 cylinder. Not sure if rectifier is hooked up correctly. I only have a seloc manual and don't completely trust the diagram. Anyone confirm which wires the 2 yellow and 1 red wire connector to on the terminal block? It is new to me so just making sure things are...

Awesome! Thanks I'll recheck that

Noticed my new to me 86 evinrude 70 hp the throttle cam has 2 marks. Not sure what the difference is between the 2? For now I link and synced using the lower mark to make contact with the carb roller when it's supposed to. Does anyone have any input on the 2 marks and which mark to go by? The...

Should I use the thermostat spring from the water pump kit?

Is something supposed to attach to those threads on the thermostat? Little confused. Also boats.net shows a pressure relief spring? Not sure what that's about thank you

Aftermarket equivalent pump was installed says it fits 432955 Tell tale hose comes off top of block