Search results

  1. K

    2.3l acts as if flywheel has missing teeth

    Just a question, have you had the battery load tested?
  2. K

    Help!!!!!volvo Penta aq125a inboard aq270 outboard

    The tried and true best way to locate the source of the fuel delivery is with a 6 gallon outboard tank and bypassing the boat tank. If the engine straightens up then the tank is where to look. If not then start checking fuel pressure and any filters before the pump. The carburetors are easy...
  3. K

    Identifying 1976 Engine-is it a 302 or a 351?

    If the manifold is a dual plane style it should work out with no problem. Summit Edelbrock #EDL-1409. 600 cfm @ $573.95. I am sending you a private message.
  4. K

    Mercruiser 5.7 carbureted wont start when warm

    I never did like that Mercarb. Too bad his engine does not have a Quadrajet.
  5. K

    Mercruiser 5.7 carbureted wont start when warm

    Is the carburetor a 2 or a 4 barrel ?
  6. K

    MCM 470 Starter Shot? Replacement options?

    Leave the small tan and yellow wires where they are on the original solenoid. Relocate the main battery cable to the large post on the new starter. Remove the large yellow cable from the original solenoid and make up a #10 gauge wire to replace it from that post to the “S” small terminal on the...
  7. K

    MCM 470 Starter Shot? Replacement options?

    If you shorten the bolts they will fit. Or have some 1/2” 13 studs turned down to stepped 7/16” 20 so a 5/8” o.d. hex nut will fit. That is what the Mercruiser conversion kit used to come with when converting from the Prestolite to the Delco style. I do not know if the other starter is easier...
  8. K

    MCM 3.7 190 cap and rotor question

    Is there excessive movement with the rotor shaft? A worn upper bushing will allow the rotor to not stay centered.
  9. K

    2.3l acts as if flywheel has missing teeth

    Check the diameter of the starter centering hole, make sure the hole in the plate is not bent inward. The hole has to match the raised area that registers the starter. Ford marine and industrial sometimes have a smaller hole than the automotive engines. If an automotive starter is forced into...
  10. K

    Reverse only

    That is what it appears to be. It might be possible to replace the cable without removing the drive. Try to get a genuine Volvo service manual for your model.
  11. K

    Reverse only

    Is the shift cable moving where it is mounted on the engine?
  12. K

    MCM 470 Starter Shot? Replacement options?

    Sierra # 18-5907. Delco No core required Sierra# 18-6949. PMGR style new. The Prestolite never did hold up on the 470s. They make good drift anchors.
  13. K

    Overheating issue.

    Whenever you run the drive in a tub you must have the flushout on the drive. The pump will not be able to raise the water enough. Also you want to keep the exhaust bubbles away from the intake grill.
  14. K

    Is My Impeller Bad? Mercruiser 228

    How does the temperature read above 3500 on plane?
  15. K

    5.7 ENGINE OIL PAN

    The Good Wrench drain thread is 1/2”-20. I used many of those engines as replacements for cracked blocks. Sometimes I had to drill out the drain plug and weld a female pipe thread fitting to it. Then make up a new dipstick tube with some 3/8” steel tubing.
  16. K

    1969 Volvo 280. /. Donzi St Tropez

    Are there any boat salvage yards in your area? If you can locate a rotted out hull with the engine combination that I posted you may be able to piece it together. Try to stay with a Volvo set up first. It does not have to be a V8. The attaching parts on a 290 drive can be swapped around to...
  17. K

    removal of steering cable

    If you have the drive removed then all that is left to do is to remove the screw like the one at the helm, pull out the shaft then just un bolt the bracket mounting the cable housing.
  18. K

    5.7 L 574APARY STARTER PROBLEMS, please help, if possible! Thanks!!

    You can try replacing the starter drive with a NEW one and not a rebuilt one. Your starter may still be good but a worn drive can cause problems. When starters are rebuilt the rebuilders usually use rebuilt drives. So, if you have a rebuilder in your area be sure to tell them you want a new...
  19. K

    1969 Volvo 280. /. Donzi St Tropez

    You need to find a 290 set up. The 280 trim system was a PITA the way the trim cylinders were and the hydraulic hoses. Your engine will connect up to it with no problem. The only other alternative would be to find a Mercruiser from 1976- 79 that used the Ford engine for the flywheel housing...
  20. K

    1977 470 Mercruiser trim issue ( helpppppp)

    Gently tap around of the top of the trim motor. If it starts running again then you probably have the brushes stuck in their holders or they are just worn out. If the armature is not pitted and the brushes are stuck be careful removing the commutator head. There is a small ball bearing in the...
Top