Search results

  1. alldodge

    Mercruiser 4.3 tks

    Going from a 4bbl to a 2bbl will not make the boat run slow. The 2bbl reduction in HP is not that much. The carb leaking gas could cause the reduction in speed. If you do a compression test it will tell the health of the motor
  2. alldodge

    Mercruiser 4.3 tks

    Not real sure of all the questions your asking, but will try to answer what I think your asking There is nothing wrong with the TKS carb, but could also replace it with a Merc 2bbl or Rochester 2GC carb, and would cost less The ease of getting the broken bolt out all depends on how it broke...
  3. alldodge

    Trim won't stay in the up Position

    In most cases its the trim control switch in the throttle handle. Mine started doing that a couple years ago and just needed a new switch
  4. alldodge

    I just joined the group

    Welcome to iboats Scott
  5. alldodge

    wiring slave solenoid

    Jump at the starter and get one click, this shows its either the starter, weak battery or bad connections with the battery cables A fully charged battery is 12.7V Reading 12.43 means its still good If cables are clean and tight then you need a starter, or need it rebuilt
  6. alldodge

    wiring slave solenoid

    Your drawing shows a slave relay and the starter solenoid. The slave is also being caused a solenoid which is ok So far as a click, multiple clicks or no click means different things, and this all depends on what testing tells us A solenoid is a electric switch. When it clicks it closes the...
  7. alldodge

    Identify this Prop Lock

    If all else fails, use a die grinder
  8. alldodge

    Identify this Prop Lock

    Looks like a Mcgard https://mcgard.com/marine/propeller-locks/
  9. alldodge

    Shifting issues related to electrical wiring

    The middle one shows both the oil pressure switch and the oil pressure sender. Switch connects to the ground side of the alarm circuit. The sendor goes to the gauge via the Blue wire. In many cases the oil switch/sender are Tee'd together at one location Same goes for the water temp switch...
  10. alldodge

    Shifting issues related to electrical wiring

    I'm using the wiring diagram you posted. A motor with points would have one wire from the distributor to the negative side of the coil. There would also be a wire from the same post which would go to the Tach. Your drawing shows a Blk/Gray wire connecting to the same locations Merc and Volvo...
  11. alldodge

    Shifting issues related to electrical wiring

    Think the Tan/Blk and Blk is for the alarm. It connects to the oil pressure switch and water temp switch. May just be for another switch that is not connected or removed Trouble with shifting is most likely from the ESA module. The module is used to cause a brief firing interrupt so the...
  12. alldodge

    wiring slave solenoid

    The ground wire may not be there and its ok, because the engine block is also ground Your saying, the solenoid clicks when the key is turned to start, but the starter does not energize? If so the starter may be the issue. Use something and jump from the main starter post to the small terminal...
  13. alldodge

    Hydrolocked in the parkinglot

    You can see air coming in, first one right side facing motor
  14. alldodge

    Bravo 3 bell housing removal. (lube leak)

    Brass can be found with parts list above 22-18922 The plastic is 22-861150T02
  15. alldodge

    Hydrolocked in the parkinglot

    Thinking its sucking air or there is an issue with the impeller. Place some clear hose at the thermostat housing on the hose coming from the drive/pump
  16. alldodge

    Bravo 3 bell housing removal. (lube leak)

    Parts are items 1 thru 5 https://www.mercruiserparts.com/bam/subassembly/30966/952/180
  17. alldodge

    Mercrusier 5.0 MPI (2008) RPM stops @ 3200.

    First post list replacing cap and rotor Guess we should have made sure you did that :unsure:
  18. alldodge

    Merc 5.7 Carb Help

    Hey Bondo Maybe he buys a rebuilt one for 350 and installs it for 250 :ROFLMAO:
  19. alldodge

    Merc 5.7 Carb Help

    One of my boats is a 95 Rinker with the Weber carb and it still runs fine. Did adjust the choke some years ago, but otherwise it has not been touched
Top