Search results

  1. C

    I need help, boat runs rough and stalls. I pumped new gas and lots more.. I need help

    The choke is immobilized by the throttle under closed and open settings. Loosen the screws around the choke black plastic housing. Open the throttle and turn the choke housing until the choke just closes....no more. If the choke plate moves with the choke housing, the mechanism is likely...
  2. C

    Help with lower unit

    Gee, what about telling us the year and HP? Newer motors can usually get replacement gearcases from SEI.
  3. C

    Control replacement/update opinions

    Gee, that is a real lot of play. My neighbor had a fast (50mph) boat with a turn or more of play in the hydraulic steering. I am surprised I lived. I hope the new steering system fixes it.
  4. C

    Merc outboard serial number question

    It has the older style starter, like my 1973 850. I did not see the old ugly orange coil, like the '73's had. Does it have the newer black square rectifier or the old rectangular rectifier, with the colored decals? You might check the block part numbers. That could narrow it down.
  5. C

    Restoring a trailer vs replacing a trailer

    You might see if eastern marine has a longer tongue that will fit. They are a pretty good source for trailer parts. You may need to move the axle to restore balance.
  6. C

    Control replacement/update opinions

    You have a Mercruiser, right? Usually with power steering on the Mercruisers you do not need the NFB Steering systems. You could use a trim tab (anode) to get rid of some of the torque steer, if it bothers you. Remember NFB steering only holds the steering wheel where you let it go. You...
  7. C

    I need help, boat runs rough and stalls. I pumped new gas and lots more.. I need help

    Does the choke plate close when the engine is cold? It sounds like the accelerator pump is working, but you should verify. What do the spark plugs look like?
  8. C

    2001 40ELPT 4S issue

    Check compression and spark to make sure all cylinders are healthy. Is there a mixture screw on the carb? If so, can you richen it a bit and see if that helps? The 2 cycle Mercs need a bit of a rich idle mixture to accelerate, not sure about the 4 cycle Mercs.
  9. C

    2013 Mercury 20 1F20201HK Leaking gas out the carb mouth (Solved)

    Carbs work on the Bernoulli principle. Higher velocity air has a lower pressure, than lower velocity air. So if gas was sprayed thru the carb jets into the throat, because of that low pressure, I would think it would then be sucked into the engine, using the same airstream. I would expect the...
  10. C

    Sea Nymph fishing boat decals

    There are duplicate decal makers on the internet. They make decals for outboard engines and other kinds. You might see if they have something or can make you something.
  11. C

    Mercury 85HP Thunderbolt Ignition Series??? Whats missing??

    The IL6 motors converted to ADI ignition in mid 1979. The IL4 motors converted to ADI ignition in 1975, if memory serves.
  12. C

    Mercury 85HP Thunderbolt Ignition Series??? Whats missing??

    Merc850 is likely correct. I do not know if any 1150/1500 had the dual triangle fuel pumps. Some might have. A lot had the single figure 8 fuel pumps. With some transfer covers from the motors with that figure 8 fuel pump, and some creativity, you could probably retrofit it. The ign wiring...
  13. C

    what to use to line ski locker

    Anything you glue to the ski well wall will allow moisture between the lining material and the FG. It cannot practically be kept out using glue, caulk etc. Mold can develop in that moisture. If you want a solid material on the ski well sides and bottom, it must not absorb moisture and allow...
  14. C

    1997 wahoo 1750 with Mercury 90 HP 90ELPTO, Changed my console and need wiring diagram from motor to console

    You will need to know the year of the motor. The maxrules web site has common wiring diagrams for motors.
  15. C

    Mercury 85HP Thunderbolt Ignition Series??? Whats missing??

    Yes, depending on the year of the 115, many parts are interchangeable. IL6 motors before 19791/2 will share ign systems except for distributor caps and disks. They share carbs, (possibly) fuel pumps, fuel/ign linkages, stators, rectifiers, midsections, triple clamps, (possible) PTT units and...
  16. C

    Mercury 85HP Thunderbolt Ignition Series??? Whats missing??

    That motor needs +12VDC on the red and adjacent white wire on the switchbox to have spark. The red wire is hot at all times, the white wire is powered by the ign keyswitch. This presupposes the engine wiring, coil and trigger are good, which is questionable at the age of that motor. Check the...
  17. C

    what to use to line ski locker

    How about plastic milk crates. If you can find some that fit tight, they drain and will protect the sides and bottom of the ski well and are mostly indestructible. They can hold spare props, anchors, oil etc. Alternatively, the old cheap indoor/outdoor carpet is a synthetic felt like...
  18. C

    Fuel question(s)

    Gee, for small 4 cycle engines, run the carbs dry, and toss 1/2 oz of 2 cycle oil in the empty fuel tank, and store them away for the winter. If you want to store them with fuel in the tank, use some stabilizer. Fog them if you want...it won't hurt. for multi cylinder engines, stabilize the...
  19. C

    Evinrude Sportwin steering linkage - need help

    Gee, that is hard to see, but it looks like the steering cable is bolted to the hull, without a swivel fitting. The swivel fitting allows the motor to be trimmed and tilted up and still steer. You will need some sort of strong connection from the cable to the motor. A drag link only moves in...
  20. C

    Fuel question(s)

    To clarify, The propaganda I referred to was that alcohol mixed with gasoline was bad for motors and caused all kinds of problems. It can be bad for older fuel lines and gaskets, and is bad for fiberglass fuel tanks. It also loosens latent dirt in the fuel system. In the long run that is a...
Top