Search results

  1. R

    1986 140 hp Evenrude

    Running on 2 cylinder would be the reason for low power output.
  2. R

    2000 115 johnson. Loss of power on top end

    I thought trim wires are blue for up ( sky is blue ) and a green wire for down ( grass is green )----Other wires might be for a trim gauge.
  3. R

    1986 140 hp Evenrude

    Glue 2 pieces of wire on a piece of carboard.-----3/8" gap between them.----Then one end in the plug boot.----Other end clipped to the block.
  4. R

    coils (newbee)

    Your location ?-----Check on the ----aomci-----website for hundreds of members that might help.
  5. R

    '84 evinrude 6hp E6RCRM

    Timing does not go out of adjustment.----Not much you can do with a timing light.
  6. R

    1973 18 hp evinrude Driver Coil test

    How does it run with cowling off.?----Do you have a fan blowing exhaust away ?
  7. R

    1971 25hp run J4J Champion? Or ....

    Use the ---J4C------Make sure thermostat is working properly.
  8. R

    1963 10hp Johnson QD-24 Flywheel rotating the mag plate

    Using the 3 bolt ( grade 5 bolts ) puller is the only way to pull flywheel.-----Nor sure how you can have issues with that method.
  9. R

    Johnson 20R71S 20 HP

    Some will argue.----If I was going to use a 50 year old motor as my primary fishing motor I would install a seal kit.-----If you are fixing it to run so you can sell it then no.------Most buyers think that if a motor barks and roars then there is nothing that needs attention !!
  10. R

    1963 10hp Johnson QD-24 Flywheel rotating the mag plate

    The bushing in the magneto plate locates the plate.----That collar with the 4 holes holds the plate down.----The magneto plate must rotate easily.
  11. R

    Help Identifying This Evinrude?

    The -----EO-----Makes it a 1995 model !!!---Now if it is ---ED----Then it is a 1996 model.
  12. R

    1963 10hp Johnson QD-24 Flywheel rotating the mag plate

    Ignore that notch.
  13. R

    1978 Johnson 70HP head scratcher

    Well ----12 volts from the battery is not used to make spark on this engine.
  14. R

    1963 10hp Johnson QD-24 Flywheel rotating the mag plate

    Is the magneto plate very loose ?
  15. R

    1987 Johnson 90 VRO Outboard J90TLCUR

    Mix gas and oil at 50:1 until you verify VRO is actually working.----New water pump impeller.-----Test overheat horn.-----Compression test.----Post your numbers here.-----Takes about 30 ounces of oil.-----So get 40 ounces.-----Fill oil from the bottom till it comes out the top screw ( u-tubers...
  16. R

    Johnson 20R71S 20 HP

    Install a new water pump impeller.-----Install a complete seal kit in the lower unit.
  17. R

    1986 140 hp Evenrude

    I can not see , hear or feel your motor.----Post your compression values.-----And does spark jump a gap of 3/8" or more on all leads ?
  18. R

    1963 10hp Johnson QD-24 Flywheel rotating the mag plate

    Coils have to be adjusted in a wee bit.----Yes there is a tool available to set the coils in the right spot.
  19. R

    Turning a 1995 50hp triple into 60/70 hp?

    No such thing as fuel injection on those motors.-----Perhaps the Evinrude Ficht models were or the EVIZUKI 4 stroke models.
  20. R

    1977 johnson 115. Idles up to 6k but won’t push boat up on plane

    If you are winding it up to 6000 RPM on a trailer at home you are wasting your time.----It will damage the motor .----It will run to 6000 RPM on 2 of 4 cylinders.
Top