Search results

  1. alldodge

    Trouble bleeding air

    Don't know if you have to, but all diesels won't run with air in the lines or won't run very long. If there is a bleed screw I bleed it.
  2. alldodge

    Bravo 3

    Yes https://www.mercruiserparts.com/865344a01-clutch
  3. alldodge

    Volvo 5.0 gxi Stalls at idle. Hard start.

    I would think it should stay full, the antisiphon valve should keep it from flowing back once filter is full
  4. alldodge

    Flywheel bolts came apart

    Most likely its just the bolts, the PO didn't use loctite
  5. alldodge

    Trouble bleeding air

    Your boat may have a antisiphon valve on the tank fitting. Its a barbed type fitting which has a check ball inside. Can also use a fuel can and just stick the line in the tank to get all filled up
  6. alldodge

    Bravo 3

    This is the items and where to look
  7. alldodge

    Leaving Tampa, Osprey, Fort Myers ? ?

    Haven't heard yet because everyone has left, but wife's Aunt being in Englewood is said to already have 8 ft of water
  8. alldodge

    Random cutting out 4.3 mercruiser

    It takes 10 to 20 minutes from motor cold for the TKS module to totally retract. That's the only thing right now that would take about that long
  9. alldodge

    Electrical Issues 8.2 mercury Horizon

    ok, a boat gauge may not be accurate. I'm seeing 12V on the gauge which should be enough to at least try. Its not trying so the PCM is seeing voltages lower. It could be on the 12V side or the 5V side. Sensors use a 5V circuit coming from the PCM. Would need to measure voltages at the...
  10. alldodge

    Electrical Issues 8.2 mercury Horizon

    ok, its a single engine boat so it would not have axis. Also being an inboard it would not have a trim sender With gauges not coming ON then need to check voltages at the gauges. If no power then kill switch, breakers, fuses Neutral safety switch Need a scanner with these new motors to get...
  11. alldodge

    Electrical Issues 8.2 mercury Horizon

    Seeing you have DTS, does the boat also have Axis? If it does need to look for a trim sensor fault. If the trim sensor has an issue the motor will not be allowed to start because the PCM doesn't know where the drive is.
  12. alldodge

    Electrical Issues 8.2 mercury Horizon

    Do you have 13V at the starter post?
  13. alldodge

    Electrical Issues 8.2 mercury Horizon

    Geezers you had it ruff, and have yet to find a Merc certified mechanic. Lots of shade tree Mechs. Most likely your original PCM has nothing wrong with it What is the motor serial number? Measure the voltage at the Bat before starting and after starting. Then measure the voltage at the...
  14. alldodge

    Bravo 3

    Older springs, were changed to orange at 1997 and 1/2
  15. alldodge

    Bravo 3

    Appears the corner edges have a small radius on the other edges. If the edges do have the radius then its the newer style. The springs should be orange color. The shift yoke should have a yellow stripe on the back edge. The top of the clutch should have a shallow grove on the inside of it...
  16. alldodge

    How's this Merc 2007 5.0L MPI sound?

    The ticking is the only thing that bothers me, but no clue what it is
  17. alldodge

    Leaving Tampa, Osprey, Fort Myers ? ?

    Wife's Aunt is leaving (south of Tampa) toward Wife's Brother (Salt Springs)
  18. alldodge

    Cancer sucks

    Yes it does. Sorry for your loss
  19. alldodge

    RWD Tow Vehicle Launch Issues?

    Y'all do understand that the first Liar doesn't stand a chance, don't ya? :unsure:
  20. alldodge

    Bravo 3

    The outside means nothing, it's the inside where the drive shaft rides on the inside of the clutch. What does the drive shaft look like?
Top