Search results

  1. alldodge

    Got ME a nice something, BECAUSE!!! :)

    You guys are starting down the rabbit hole Chris is down under
  2. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    Thanks MUC that is a lot of info and a lot of work on your part
  3. alldodge

    Fuel system fail on new boat

    If you have 2 motors running off one fuel line Tee'd to the 2 motors, that doesn't work. It can work if you put valves on the fuel line to turn the motor not be used OFF
  4. alldodge

    helm cell phone mount

    Get one that fits holder, then RTV all the parts together, just don't use a lot. If later you want to change, pry it loose and try again
  5. alldodge

    Won’t stay running

    In this case, please start another thread with your issue and info on the motor and we can have a look
  6. alldodge

    Mercruiser ECM replacement?

    With those codes, it says the tps voltage is to high, so there may be an issue with it or supply voltage is getting to signal wire The other deals with the dizzy module
  7. alldodge

    Mercruiser ECM replacement?

    If you find the screen is clogged just toss it. No need for a screen that has larger holes then the filter If you have a compressor and hand adjustable Reg. Use rubber tip and connect to base of cool fuel Reg. Adjust air pressure up slowly and it should open at 30 psi
  8. alldodge

    Won’t stay running

    post 7
  9. alldodge

    Mercruiser ECM replacement?

    12 is ECM checks good 21 is TPS voltage high, so signal lead shorted to power 42 is IC grounded and or bypass open to ground
  10. alldodge

    Mercruiser ECM replacement?

    Some how I didn't get notified of the post Thursday Pumps good but can't say the same for the Reg. The pump should be capable of producing 60 psi and with the gauge going to 55 it does. The Reg should keep fuel pressure at 30 which its not doing that. It does bleed down, but it should never...
  11. alldodge

    2000 5.0 Merc

    Either the vent line to the tank is clogging, or the antisiphon valve is clogging. When motor dies, remove the gas cap and listen for air to suck in. If you hear air sucking in, then its the tank vent line The antisiphon valve is on the top of the tank and has the rubber fuel line connected...
  12. alldodge

    Startmotor 3.0L bendix difference?

    The new one is not retracting all the way. See if you can push the teeth in further. If not, remove the solenoid and look to see that actuating arm and spring is in the correct position.
  13. alldodge

    Proper Carburetor adjustment

    Your good, go have fun
  14. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    I am Groot :D
  15. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    If you ask really, really, REALLY nice maybe @muc might comment
  16. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    Not sure you posted it either, Tx Ya know, if my meter was showing 13.9 to 14V and not closer to 14.5 I would be taking measurements at the ALT and Bat's to verify my ALT was doing what it should. If output was correct and VV was showing the above, then that would be my next look as to why...
  17. alldodge

    Kohler 5E Generator shutting off after 3-5 minutes of operation

    Need to open the Gen cover so you can see the control board
  18. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    Sorry Ted, I'm not connecting, guess just getting to old. There is 14+ at the Bat's when running, but it screen pics of Diacom it shows no more then 13.1. For me that is a big issue
  19. alldodge

    Trim gauge creeping higher

    Its most likely the sender Loosen the screws on starboard side, turn key ON and adjust. Might not fix it, but worth a shot
  20. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    Can we say that while running the ALT is putting out 14.5V but the PCM does not see that level?
Top