Search results

  1. alldodge

    Toilet Installation Mishap . . .

    Looked at my Kohler's in current house (installed maybe 6 years ago) and I can get my finger tip between tank and bowl
  2. alldodge

    Gas leak gas freezeing

    That's cool but, it says super cooled (-10*) and list done quickly Standard freezer inside a styrofoam cooler, don't get the cooler in a freezer but think that has something to do with it. Water in a boat would not be quick cooled
  3. alldodge

    Gas leak gas freezeing

    Would like to see that experiment Its 40 now, was it colder prior to finding it? Probably has some oil mixed
  4. alldodge

    Gas leak gas freezeing

    Agree, its not gas, and wander what it is, water freezes at 32* not 40
  5. alldodge

    5.7 Venturi Cluster

    There is a different float setting for a solid and spring loaded needle valve
  6. alldodge

    Oil coming from exhaust riser rubber coupling

    Sounds like there was an issue, and with oil coming out the exhaust, it either has a cracked head, piston or block Do a compression test, but for the most part it does appear you will need to rebuild or replace
  7. alldodge

    Oil coming from exhaust riser rubber coupling

    What motor, and serial numbers are best? This is a new problem, as in the motor could reach WOT before? Check the oil and is it low now? Any water in the oil, milk looking?
  8. alldodge

    Toilet Installation Mishap . . .

    I don't know anything that can glue it back on and hold. Suggest fab an aluminum plate to fasten to all 3 bolts Also suggest when installing next, the tank doesn't need to be real tight (Just replaced 2 my self last year in rental, American Standard Champion-4, only one with 4 inch flush valve)...
  9. alldodge

    Rub Rail Restoration??

    Rivets 1/4 inch, screws will be unable to handle the vibration unless maybe their used with lock nuts IMO that is
  10. alldodge

    Volvo Penta GXi-E Low Power and 2 DTCs

    Assuming short run from idle to WOT and back to idle Didn't see anything that stood out, so it may just be the low fuel pressure
  11. alldodge

    motor dies and has no battery power battery

    Well not an OB guy, and would probably get more input in that section. You said the motor stops, meaning its running fine and without touching anything it shuts down? Do the gauges say ON, and are there any beeps or other things? Kill switch? Bad connection on the key switch?
  12. alldodge

    motor dies and has no battery power battery

    What motor?
  13. alldodge

    motor dies and has no battery power battery

    Start with what motor? Next remove both ends of the battery cables at the battery and the motor. Do not forget the ground attached to the block. Clean them with wire brush to shinny metal
  14. alldodge

    350 Mag MPI Horizon died at sea, cannot find the problem.

    Think you have an item which is starting to draw more current over time. From the previous drawing it can be anything which is connected to it. With the idle being incorrect and resetting when turned off/on that would be my thought, clean or not
  15. alldodge

    Help with DPS-B 1.95 outdrive

    Your low pressure is good, but high is low. The HP pump is most likely your problem. Could also be the fuel pressure regulator which is on the fuel rail (item 22 in above pic) The pic of the TB means you have a drive by wire control. Sure could use a serial number but we are getting closer
  16. alldodge

    Installing new decking question

    If the emails are not going in the spam folder post your question in the website section
  17. alldodge

    Installing new decking question

    Check at the top of the thread, you should see "unwatch". If you see "watch" then your not subscribed Next go into your settings to verify email and all is correct
  18. alldodge

    Volvo Penta GXi-E Low Power and 2 DTCs

    Looks are deciving, use your ohm meter and connect from pin C to ground and see what kind of ohm reading you get. Ohm out the other connector pins as seen in post 4
  19. alldodge

    Volvo Penta GXi-E Low Power and 2 DTCs

    Ted, Its an EST module but not in the distributor. The module is mounted to the coil and it uses the HSV distributor (flat cap)
  20. alldodge

    Volvo Penta GXi-E Low Power and 2 DTCs

    I don't have diacom (have Techmate) but maybe @tpenfield can have a look Check the connections coming from the ICM, and insure the ground pin is making a good ground Are any of the parts replaced non-OEM? Not saying they are bad, just taking note of The cam and crank plugs in good shape and...
Top