Timing is not advancing far enough so you have lower power. The DTC-41 is the ECM is getting a high or low signal (not normal) on the ignition timing circuit. Voltage variance could be from the component, bad ground or power connection.
Input to the ECM comes from the Cam position (if...
As a non-expert, I think its a 1978 115hp 6 cylinder
Used the the one on the transom bracket
https://www.mercurymarine.com/en/us/faq/?category%5B%5D=parts-and-accessories&category%5B%5D=outboard-model-year
This is what I used to determine year...
Its corrosion welded to the assembly.
I sounds like the motor is still in the boat, and if so its real hard to be able to apply enough power to break it free.
Have you tried to put some heat on it from the stern side. Careful use of a torch
True sad story, and no one died
Friend of mine which has a brother which was doing SAR ops with Sheriffs office and National Guard. Dropped off folks at a pier and was going back to pick others off of island and large wave tossed him out of the boat. Boat kept circuling several times and he...
Any LEO can site for the issue, doesn't matter if it didn't come with one. My Rinker came with one and the tether has never been used, its in the glove box.
My 70 something Chrysler didn't come with one, but I was planning (prior to this post) on installing one because its so small
Howdy
Was this done when the motor was not starting or after its back on the trailer?
To check if your drawing a vacuum the motor must be running until it starts to die. With motor OFF the gas cap is removed and need to listen of air sucking in.
From your posting my first guess is it is the...
I would work but not sure for how long, enamel isn't a good water sealer.
Could coat all sides and even more so the edges with epoxy paint. The epoxy would last longer.
How would the deck be held in place? Normally there are screws on the inside covered by glass. The glass tabbing on the...
