Search results

  1. M

    coverting to power trim

    I Have A 1976 Merc 500 That I Am Going To Replace With A 1977 Merc 70. The 70 Does Not Have Power Trim/tilt. My 50 Hp Does (i Have A Pump And Motor That Sits In Back Of Boat And Transfers Fluid Thru Lines To Motor. Can This System Be Adapted To The 70 Hp Motor ? (the Mounting Areas Look Similar...
  2. M

    rebuild time?

    I Took My 1976 Merc 500 To Dealer For Link And Synch To See If They Could Get Better Performance Out Of It. I Had Been Having Some Trouble Starting And Thought This Would Help, They Found Water Getting Into Bottom Cylinder So I Told Them To Go Further. They Pulled Power Head And Removed Exhaust...
  3. M

    merc 500 hard cold start

    I Have A 76 Merc 500, Rebuilt The Carbs, Flat Levels Set Perfectly, Issue Is When I Have To Start It Cold It Cranks For A Second And Coughs, Then I Have To Keep Cranking Starter, It Takes Many Times Of This Before I Can Get It To Fire Up And Idle. Choke Works Fine, Primer Bulb Gets Hard. Once...
  4. M

    See If Anyone Knows The Answer To This One?????

    so, i have a 76 merc 500 and have been chasing a bog. I had a slight bog when hitting the throttle that i couldn't remove by adjusting the idle mixture screws. . I adjusted floats and reinstalled carbs, bog still there. all of this testing has been done with motor running on muffs. what i...
  5. M

    checking fuel pump

    I have a 76 merc 500 and want to know if fuel pump is bad. it had fuel pump built into side of carb body with the little blue fuel inlet caps that say tillotson. i blew into the fuel inlet and can hear air rushing into carb until i raise float, then i can't blow anymore. my fuel line bulb get...
  6. M

    carb help?

    ok, my 76 500 is killing me. i pulled the carb because i had a bog when accelerating. adjusting the idle mixture screws made no difference to performance. after pulling carbs i found restriction in passage for idle mixture screw. cleared restriction and checked rest of carb, all checked out ok...
  7. M

    oil leak??

    does anyone know what may be leaking oil from the top oif a 76 merc 500. i replaced the 2 rubber hoses on the side of the motor, behind switch box, but oil seems to be coming from under the flywheel. it is running down the engine and dripping out from lower cowling of engine. is there a top seal...
  8. M

    tach??

    I have a 76 500 and got tach to work again (bad rectifier) . it is off by 500 rpm or so, seems to be reading too high. the tach is a aqua meter tach that reads to 6000 rpm, i believe from 76 also. i believe i have at least 6 wires on back of tach. is there a newer tach i can use with this type...
  9. M

    flat spot???

    i have a 76 merc 500, have a bog when acclerating from dead stop also from any throttle setting under acceleration. idle is good, starting is excellent. i tried adjusting mixture screws on front of carbs , doesn't seem to make any difference. in fact i could hardly tell any difference from...
  10. M

    Tilt Lock Pin?????

    I Noticed On My 76 Merc 500 That My Tile Pin Is Rusty. I Am Talking About The Pin That You Swivel When Motor Is Tilted Up For Trailering. This Pin Swivels Down By Hand To Take The Weight Of The Motor Against The Bracket. My Pin Is Rusted In Center And Is Bent Out Of Shape. Looks Like It Is Going...
  11. M

    Fuel Coming Out Of Carbs??

    I Noticed When My 76 Merc 500 Is Tilted Up I Am Getting Fuel Coming Out Of The Carbs . It Is Soaking In Front Of Carbs And Dripping On Carbs Themselves, Worse When Trailering. What Gives???????
  12. M

    Carb Question

    I Have A 76 Merc 500, Took It Out Today For First Time Since I Bought It Last Month. Motor Runs Great, Idles Fine, Starts Fine, Has Good Power. My Question Is There Is A Bog When I Acclerate. The Bog Is Not There When Revving Engine In Neutral. It Is There From A Dead Stop And When Hitting...
  13. M

    Tach Question

    I Have A 76 Merc 500 And The Tach Is Not Working Properly. The Tach Won't Read Above 3000 Rpm, But It Works Ok From 1000 To 3000. I Assume The Motor Is Revving Higher Than This Because When I Give It Full Throttle It Seems To Go Into Its Powerband And Plane The Boat. Boat Is A 16 Foot...
  14. M

    need some help

    I Have A 76 Merc 500 50 Hp And Just Got It Running, Took It Out Today Seems To Run Nice. , There Is Oil Coming From The Top Of The Powerhead And Running Down Near The Carbs. I Thought The Carbs Were Lekaing But The Oil Starts Above The Carbs, Looks Like Under Flywheel? Anyone Know What To Look...
  15. M

    wiring help????

    hi, i have a 76 merc 500 thunderbolt and was wondering if i change the internal wiring harness for the motor,. the stator , and the trigger, will i have taken care of all the wires in the motor?? my wires are brittle and the insulation is crumbling. also the small wire that goes to the starter...
  16. M

    wiring help

    I Have A 76 Mercury 500 That I Need Help With. The Wiring In The Engine Is Not In Good Shape. There Are Small Wires Coming Off The Switch Box White Wire In Particular (that Looks Like It Runs Up Under Flywheel) . The Wire Insulation Is Crumbling When I Touch It And The Bare Wires Are Really...
  17. M

    top rpm?????

    anyone know what top rpm i am shooting for?? 1976 mercury 500 50 hp on 16 foot aluminum center console. thanks
  18. M

    kill switch

    Can Anyone Tell Me How To Go About Installing A Kill Switch For A 1976-77mercury 500 With Thunderbolt Ignition. I Would Feel Much Safer Having This. Where Can I Get A Kit ?
  19. M

    advice 1976 mercury 500

    I Am Purchasing A 1976 Duranautic Offshore 16 With Center Console And 1976 Mercury 50 Hp. I Checked Compression Of Motor And Got 120,132,120,125, Are These Good Numbers? Spark Is Strong On All 4 Cylinders When Checking. I Didnt Start Motor And Hasnt Run In 3 Years, I Need Some Advice On What To...
  20. M

    Help!!!!!!!!!

    I Am Looking To Purchase A Boat With A 2000 Mercury 90 Hp. The Seller Says Something Is Wrong With Motor. He Bought Boat Last Year And On The First Outing The Motor Stopped While At High Speed, It Would Not Restart Just Cranks, He Got Towed In And The Yard That He Had The Boat At Says He Has...
Top