Search results

  1. C

    1999 Evinrude (90 hp) E90FPLEEC - Runs fine at idle speed. But stalls when running about 3000 rpm

    well there you go... better fix what ails it then ... Racerone.... any technical reason why premixing would not work .. be it 50/1 or 40/1 if the needed parts are truly NLA anywhere ? Is it the end fatality of the engine ?
  2. C

    1979 Evinrude 35 hp Water Pump Issue

    we love happy endings :-) :-)
  3. C

    Trim

    see pict. in the non operating mode both blue and green are grounded with either wire waiting for the other to flip to +12V thus reversing current flow to the trim motor
  4. C

    Trim

    or better said by the ETEC FOLKS.....
  5. C

    Trim

    green and blue motor works both ways so Voltage/current must be presented in alternate directions ..up or down since the motor can trim UP ok then both wires from the relays are ok and do pass juice to the motor because one wire has 12v and the other is grounded. In the...
  6. C

    1999 Evinrude (90 hp) E90FPLEEC - Runs fine at idle speed. But stalls when running about 3000 rpm

    first things first... up to you... .me I would just open the VST to check the vent float and needle. VST is just a can with a water coil to cool the fuel and let vapors escape via the top needle valve. they have been know to become stuck/rusty if the incoming fuel is contaminated with...
  7. C

    1979 Evinrude 35 hp Water Pump Issue

    3 inches underwater may not be enough to prime the pump properly . Remember the old farmer's hand pumps.... they needed a quart of water to start pulling water from the well. retest with the LU submerged and spin it with the drill to confirm the pump is pushing water out the pump body...
  8. C

    Temperature switch circuit 2000 Johnson 150hp

    If my compression readings are indeed low at 92-94psi would this not be enough to pulse the fuel pump causing it not to pump fuel? Actually compression#s inside cylinders have nothing to do with the vacum (crankcase pressure loss during the piston up stroke) inside the crankcase. the...
  9. C

    understanding idle on 1971 Johnson 50 hp

    to idle properly the idle circuit of the carb must be clean to allow proper fuel vapors to be generated by the upper part of the carb. If you feel adventurous pull the dime size plug on top (drill a small hole and use a nail to pop it out do not drill deep !! inspect /clean the small...
  10. C

    understanding idle on 1971 Johnson 50 hp

    common old style carb with a LS needle on top. have you tried adjusting the needle with small increments have you serviced the carb at all ?? easy to clean. see carb issues pictures. old carbs but same issues Yours has no HS needle on the bottom just a fix jet on the bottom...
  11. C

    1999 Evinrude (90 hp) E90FPLEEC - Runs fine at idle speed. But stalls when running about 3000 rpm

    don't assume the small lift pump is bad you also have the fuel filter asa possible source of restriction....then the VST needs to vent properly otherwise entry into the VST of new fuel will be compromised . Check vst top cover for a small float valve/needle which closes when the VST is full...
  12. C

    Temperature switch circuit 2000 Johnson 150hp

    I can manually choke it, pump primer bulb until I get fuel into the manifolds and it starts fine.... anything wrong with the lift pump ?? feeding the vst no expert on these big engines but.... Carbs look like regular old style float valved carbs. Strange that no fuel reaches them .... any...
  13. C

    Trim

    maybe this can help basic 2 wire ptt the relays simply forward or reverse the current to the trim relay. if motor works one way seems logical it should work the other way (wires to the motor being ok ) and the big IF is ..... are relays applying juice to the motor in the...
  14. C

    1957 35 Johnson (carb adjustment)

    great news ... thanks for your feedback. Lots of folks just go off in the blue and never come back with good news :-)
  15. C

    Johnson TN 26 5HP impeller replacement

    see pic
  16. C

    Boat shuts off after a few seconds.

    see pic.... yellow areas subject to clog and sticking (needle)
  17. C

    Boat shuts off after a few seconds.

    how about doing the carb 14 years of dried fuel may be clogging things need new impeller gearcase oil etc.... to wake it up properly check compression
  18. C

    '65 Sportwin 9.5hp prop shaft play

    also check the side shift link (shift rod connector) for proper fit
  19. C

    '65 Sportwin 9.5hp prop shaft play

    any chance the shift lever is not adjusted properly
  20. C

    1978 Evinrude 85hp fuel pump question

    on the parts place... they show a common pulse pump (pulsing vacum is at the rear) .... with one cover hose sucking gas via the cover filter and one exit nipple where the fuel output gets distributed. Very common setup with lots of cheaper chineese pumps if you wish to save some $$$...
Top