Search results

  1. phillnjack2

    Weak pee stream hot also bad -weak pump?

    Re: Weak pee stream hot also bad -weak pump? Play it safe and have a look at the water pump impellor. Unless you actualy do it yourself and see waht your putting in,then never take the word of a previous sellor. it sounds like the impellor is bad to me, take note that just by looking you still...
  2. phillnjack2

    part from a 2000 60hp evinrude. what is it?

    Re: part from a 2000 60hp evinrude. what is it? if your engine is a 3 cylinder and it was built from 1995 onwards it definitely should have the one pictured. whether with or without power trim that is the regulator/rectifier for that engine. there is NO other part number listed for a regulator...
  3. phillnjack2

    Temperature guage sender for evinrude 60hp

    1995 evinrude 3cyl 60hp Model no BE60TLEOC Serial no G 03751787 I am trying to find out the thread size or locate a temperature sender and guage for my outboard. On the top of the water jacket just up a touch and to the right of the top spark plus is a threded hole that can take a temp...
  4. phillnjack2

    How big of outboard can I put on 12' appleby jon boat.

    Re: How big of outboard can I put on 12' appleby jon boat. 12hp !!!!!!!! put a pic of the boat on if you can because if its what is in the appleby chart it was only rated for 7.5hp and total weight of 450lbs. But outboards back then were pretty heavy for their size. i would be thinking a 12hp...
  5. phillnjack2

    Overheat alarm on 1995 evinrude 60hp

    Re: Overheat alarm on 1995 evinrude 60hp well your right about 3 wires going to the vro plug, oil tank, and big red plug. Now the other 2 wires that was attached to the diode on other side goes for about 3 inches then they just connect to each other ??? so they are doing nothing at all. (...
  6. phillnjack2

    Overheat alarm on 1995 evinrude 60hp

    Re: Overheat alarm on 1995 evinrude 60hp Hi WernerF I understand what you say about " Does the buzzer sound , If yes, you have an open cicuit between this point and the temp sensor connector. But the temp sensor tan wire goes straight to the powerpack from what i can see, it dont look like...
  7. phillnjack2

    what is causing my evinrude to go into SLOW MODE ?

    Model no BE60TLEOC Serial no G 03751787 Year 1995 USA well today i took the boat out for a test run and for the first hour or so it went fantastic. over 40mph and reving as it should. a couple of times i slowed down a bit and just cruised and all fine, opened it up again and it ran great...
  8. phillnjack2

    Overheat alarm on 1995 evinrude 60hp

    Model no BE60TLEOC Serial no G 03751787 Year 1995 USA I have today been checking various things on my engine,plug leads and all electric fittings etc. i checked the alarm in the control box that i just recently fitted. I have the vro removed from the engine and run of old type fuel...
  9. phillnjack2

    Water Seperating Fuel Filters for 2 Stroke Pre-Mix ?

    Can anyone tell me if water seperating fuel filters are ok to use with 50-1 2 stroke pre-mix ? You see ive taken off the vro:mad: (cannot trust it ,no way) but would still like to use a water seperating fuel filter. I like the ones with a clear bowl on the bottom and the filter canister above...
  10. phillnjack2

    evinrude 60hp temp sender 2 wires ???

    Evinrude 60hp 1995 the temp sender on this engine has 2 wires comming out of it. 1 wire is tan with blue stripe the other is white with black stripe. what exactly are these wires ? how can i test the sender ? the sender is infront of me out of the engine so i can easy put it in boiling...
  11. phillnjack2

    How do i test the tacho pulse wire ? evinrude 60hp 1995

    Model no BE60TLEOC Serial no G 03751787 I am trying to rig up my tacho on my evinrude 60hp 1995 triple. I know the pulse is the grey wire the positive is purple and black is ground etc. But how can i tell if the Grey pulse wire is working ? i do have positive and negative at the wires but...
  12. phillnjack2

    How and where to fit a water pressure guage and sender ?

    Model no BE60TLEOC Serial no G 03751787 year 1995 USA I would like to know where on the engine to fit a water pressure sender, what exactly i need. The idea of a water pressure guage seems a very good idea to me, to keep check on whats going on. is there a bolt i replace to fit a send etc...
  13. phillnjack2

    Alarm in remote control box replacement 1995 60hp evinrude

    Model no BE60TLEOC Serial no G 03751787 year 1995 USA The alarm/buzzer/horn module in my remote control box is definitely dead.:eek: I couldnt get anything from it when testing and so took it apart to just see whats in it. The wires were just so corroded there is no way of repairing it at...
  14. phillnjack2

    Evinrude 1995 powertrim seal numbers and types

    Re: Evinrude 1995 powertrim seal numbers and types Well, after searching almost everywhere in the uk, including sever hydraulic seal company's, i have had to go to BRP agent to get the seals. All companies on the phone say bring them down and we will match for you, yeah right. As soon as the...
  15. phillnjack2

    What power trim oil to use in 1995 60hp with fastrak system ?

    I am just in the process of completely rebuilding the power trim on my 1995 evinrude 60hp. Model no BE60TLEOC Serial no G 03751787 The trim unit is the Fastrack system, and im replacing all seals and also putting in brand new rams. Im now not sure what oil to use exactly, as the manual...
  16. phillnjack2

    1995 evinrude 60hp spark plugs..

    Evinrude 60hp 1995 3 cylinder Model BE60TLEOC Serial no G 03751787 I have a bit of a dilema with getting spark plugs for this engine. i cannot localy get the recommended champion spark plugs, i can only get NGK.:( i went to local marine shop armed with the champion spark plug numbers, but...
  17. phillnjack2

    Evinrude 60hp 1995, realy getting me down now...HELP NEEDED

    Re: Evinrude 60hp 1995, realy getting me down now...HELP NEEDED My friend has took the ordinary fuel pump off his engine tonight for me to try on my engine :eek:.. We know his pump is very good and strong :p Tommorow ill take off the vro completely and put the old style non vro pump on and see...
  18. phillnjack2

    Evinrude 60hp 1995, realy getting me down now...HELP NEEDED

    Hello everyone I have a Evinrude 60hp 3 cylinder,1995 model and i think its been cursed by a DEMON who hates water. Model no BE60TLEOC Serial no G 03751787 My latest problem is driving me nuts. I disconnected the vro as soon as i got the engine to be on the safe side and use pre-mix at...
  19. phillnjack2

    tohatsu 25hp double firing ?

    Hello everyone A friend of mine has a tohatsu 25hp that is in good condition with good compression model is M25A2 We had a problem in the coil and it completely died, so we got another secondhand coil due to no new coil availabilty. this worked for a few weeks then that too packed up due to...
  20. phillnjack2

    Evinrude 60hp 1995 cdi wiring ? HELP needed

    Re: Evinrude 60hp 1995 cdi wiring ? HELP needed thanks WernerF So unless the engine was over reved it would not make any difference to normal running !!! But what exactly is this slow mode ? is this something to do with over heating alarm ? so glad to know there is people out there who...
Top