Search results

  1. D

    1989 90hp Merc trim won't work

    a friend has a 1989 3 cylinder 90hp Merc with the 3 ram style trim unit. when you push the trim button you can hear the solenoid click but the motor doesn't move. Up or down. I loosened the release knob and the motor slowly goes down but I can't lift it up....we made sure the battery was fully...
  2. D

    1973 9.5hp Johnson weak spark?

    what usually causes weak spark on an outboard with points? she starts and runs but not very well. loss of power and full speed and rough idle. tried testing the spark and I believe its weak...
  3. D

    Real weight of a Merc V/6 ?

    looking at getting a V/6 merc and i'm wondering why there is such a big weight difference between a 1989 150hp and a 1988 175hp? The 1989 150hp is listed at 395lbs, the 1988 175hp is at 358lbs. Anyone know why the 150 is so much heavier?
  4. D

    Low compression heads...

    I recall reading somewhere that some OMC motors had factory installed low compression heads. Was it just V/6 motors? or did some v/4's have them too? and what years? anyone remember?
  5. D

    Need input about a 1996 Force 120hp by Mercury...

    Looking to repower my 1995 17' Nitro Bass boat. Found a 1996 120hp Force. I've never owned or ran one before, how do they compare to mercs and omcs of the same hp? What are things to look for that might have been issues with this model if any?
  6. D

    1983 140hp V4 Johnson compression test...

    This is the 99.6 c.u. model. what compression should it have? the one I found the guy says it runs great, pulling the kids tubing and all that but he said three cylinders have 110psi and one has 90psi. would a motor with these numbers even produce 140 horse power?
  7. D

    1992 18hp Nissan carb issues...

    trying to repair a 1992 2-stroke 18hp Nissan. Model number NS18C2. She leaks fuel through the carb and needs a new float needle. when I go to look up the part number it just shows "obsolete" and doesn't give the part number. Anyone happen to know the number and where to order one? Also, whoever...
  8. D

    right spark plugs for an Evinrude 70hp?

    1986 70hp Evinrude has champion L-3G plugs in it. I've never seen these before...are they the right ones?
  9. D

    Spark plugs for a 70hp Evinrude

    1986 70hp Evinrude has champion L-3G plugs in it. I've never seen these before...are they the right ones?
  10. D

    prop for 15hp Johnson

    does anyone know of... or have a high performance prop for a 15hp Johnson?
  11. D

    Removing the starter from a 1985 35hp Merc...

    Trying to replace the starter on a 1985 35hp Merc, got the front cowl piece loose and the bolts to the starter removed but there a bracket at the bottom of the starter that bolts to the front of the block under the carb. Whats the trick to get to that piece? I can't remove the carb without...
  12. D

    1983 75hp Johnson doesn't charge battery

    got a 1083 75hp Johnson that doesn't charge the battery. the tach works. would it still be a bad rectifier?
  13. D

    1990 Johnson 15hp missing carb part?

    got a 1990 15hp Johnson J15RESR. removed the carb to give her a cleaning and noticed that in the parts diagram online there are two gaskets and a spacer piece between them and the manifold and the carb. this motor is missing that part and second gasket.
  14. D

    Bringing a 1983 75hp Johnson back from the dead...

    My buddy needed a trailer, we found a 1983 Crestliner on a Spartan trailer with a 1983 75hp Johnson on it. I got the motor. She had been sitting outside unused since 2006! First I sprayed the inside of the cylinders with flogging oil and slowly turned the flywheel by hand. Then took off the...
  15. D

    1987 60hp Johnson seeps fuel out of top of carb

    my 1987 60hp Johnson started seeps fuel out of the tiny hole in the top jet of the top carb at idle. The fuel puddles in the throat of the top carb then drips down to the middle and bottom carb. Figured it needed a new needle and seat so I replaced them but it does the same still. Could this be...
  16. D

    1983 75hp Johnson no spark...

    Just picked up a 1983 75hp Johnson with no spark. This motor has been sitting outside unused since 2007. Looking under the fly wheel the contacts on the stator look green with tarnish. is it possible that just cleaning them will solve the problem? I haven't pulled the fly wheel off yet.
  17. D

    Liquid tape too thick...

    anyone know what you can use to thin out liquid tape?
  18. D

    Synchronizing carburetor and distributor on a 65hp Johnson

    bought a 1973 65hp Johnson service manual. it refers you to go to section 4 for instructions on Synchronizing carburetor and distributor but there is nothing there. was this an oversight when the manual was printed?
  19. D

    1973 65hp Johnson fuel pump issue???

    Got a 1973 65hp Johnson that starts right up great, idles nice. Took her out for a spin. She has plenty of power and pushes my 16' Sylvan 32mph with a 17"pitch prop. Ran it around the lake and did a couple of hole shot tests. Then headed back to the landing and as I was slowing down off plane...
  20. D

    Rectifier...what does it do???

    the tach on my 1973 Johnson 65hp stopped working. tried a new tach, still didn't work. Service guy said I need a new rectifier. Motor seems to run pretty good with the "bad" one still on.
Top